N4234Z Piper PA 18-150 accident

NTSB CEN16LA193 · 2016-05-24 · Cozad, NE · near 2NE5

Docket — crew, injuries and powerplant

Summary

The commercial pilot was conducting an aerial application flight about 25 ft above ground level when the airplane suddenly made an uncommanded descent and impacted a wheat field. The airplane came to rest inverted and sustained damage to both wings, wing struts, fuselage, and tail surfaces. Although the pilot noted some discrepancies with the airplane after it was rebuilt, examination of the wreckage, including the horizontal jackscrew assembly, did not reveal any evidence of preimpact mechanical malfunctions or failures that would have precluded normal operation.

Full narrative

On May 24, 2016, about 1010 central daylight time, a Piper PA-18-150, N4234Z, was substantially damaged when it impacted terrain near Cozad, Nebraska. The pilot sustained minor injuries. The airplane was registered to the pilot and was operated by Gothenburg Flying Service, Inc., under the provisions of Title 14 Code of Federal Regulations Part 137 as an agricultural application flight. Visual meteorological conditions (VMC) prevailed and no flight plan had not been filed. The local flight departed Fiese Airstrip (2NE5), Gothenburg, Nebraska, about 1000.

The pilot said he had just finished purging the spray booms of air and rinsate and was flying 25 feet above the ground when the airplane suddenly made an uncommand descent. The right wing struck the flat wheat field and the airplane skidded to a stop, coming to rest inverted about 120 feet from the initial point of impact. There was substantial damage to both wings, wing struts, fuselage, and tail surfaces.

The airplane had recently been rebuilt. The pilot/owner noted multiple discrepancies with the airplane following delivery. One discrepancy was that the jackscrew and drive pulley assembly for the horizontal stabilizer were not replaced as he had requested. He noted that the jackscrew assembly was worn and there was excessive slack in the drive cable. Pitch trim had to be constantly adjusted as a result. The builder had told the pilot that the assembly had been "tightened up." The pilot stated that this was not possible as the screw was made of steel and the housing was made of aluminum. The FAA conducted examinations of the airplane following the accident and noted play in the jackscrew assembly, but determined the slack was insufficient to cause the screw to slip. No other mechanical issues were found with the airplane.

Probable cause

An in-flight loss of control for reasons that could not be determined because examination of the wreckage did not reveal any evidence of preimpact malfunctions or failures that would have precluded normal operation. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
Minor
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
BKN
Ceiling (ft)
1000
Visibility (sm)
10
Wind direction
180
Wind speed (kt)
9
Temperature (F)
68
Nearest airport
Fiese Airstrip
Distance from field
8.0
Airport elevation
2535

Aircraft

RegistrationMakeModelDamageFAR part
N4234Z PIPER PA 18-150 SUBS 137

Sequence of events

#OccurrencePhase
1 Maneuvering-low-alt flying Loss of control in flight defining Climb
2 Uncontrolled descent Collision with terr/obj (non-CFIT) Descent

Findings

Finding
Aircraft-Aircraft oper/perf/capability-Performance/control parameters-(general)-Not specified cause
Personnel issues-Task performance-Use of equip/info-Aircraft control-Pilot cause