N5720L American AA 1 accident

NTSB GAA16CA319 · 2016-06-12 · Denton, MT · near 5U0

Docket — crew, injuries and powerplant

Summary

The pilot reported that during the takeoff roll from a soft field turf runway, "I was not as aggressive as he should have been." He reported that the airspeed increased, the airplane began to rotate, but without enough airspeed to sustain climbing flight. He reported that he "pushed the nose over", the airplane settled to the runway and bounced. The airplane overran the end of the runway, struck a fence and sustained substantial damage to both wings. The pilot reported that there were no mechanical failures or anomalies with airframe, flight controls or the engine that would have prevented normal flight operations. According to the manufacturer pilot operating handbook, for Soft-Field Take-off: Hold full back pressure as you taxi and as the takeoff roll is begun. If the surface is marginal or too narrow for gradual turn on to the runway, align the airplane with the runway, apply full brakes, and build up takeoff RPM before starting the takeoff roll. As you apply full power, move the control wheel to neutral and allow the airplane to accelerate to 65-70 MPH. Lift off with a light back pressure. After lift-off release enough of this back pressure to permit the airplane to accelerate to its best angle- or rate of climb speed as required by obstructions.

Full narrative

The pilot reported that during the takeoff roll from a soft field turf runway, "I was not as aggressive as he should have been." He reported that the airspeed increased, the airplane began to rotate, but without enough airspeed to sustain climbing flight. He reported that he "pushed the nose over", the airplane settled to the runway and bounced. The airplane overran the end of the runway, struck a fence and sustained substantial damage to both wings.

The pilot reported that there were no mechanical failures or anomalies with airframe, flight controls or the engine that would have prevented normal flight operations.

According to the manufacturer pilot operating handbook, for Soft-Field Take-off:

Hold full back pressure as you taxi and as the takeoff roll is begun. If the surface is marginal or too narrow for gradual turn on to the runway, align the airplane with the runway, apply full brakes, and build up takeoff RPM before starting the takeoff roll. As you apply full power, move the control wheel to neutral and allow the airplane to accelerate to 65-70 MPH. Lift off with a light back pressure. After lift-off release enough of this back pressure to permit the airplane to accelerate to its best angle- or rate of climb speed as required by obstructions.

Probable cause

The pilot's premature rotation and failure to attain sufficient airspeed required for a sustained climb, resulting in a runway overrun and collision with a fence. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
210
Wind speed (kt)
6
Temperature (F)
57
Nearest airport
DENTON
Distance from field
0.0
Airport elevation
3594

Aircraft

RegistrationMakeModelDamageFAR part
N5720L AMERICAN AA 1 SUBS 091

Sequence of events

#OccurrencePhase
1 Takeoff Abnormal runway contact Takeoff
2 Takeoff Loss of control on ground defining Takeoff
3 Takeoff Collision with terr/obj (non-CFIT) Takeoff

Findings

Finding
Aircraft-Aircraft oper/perf/capability-Performance/control parameters-Airspeed-Not attained/maintained cause
Personnel issues-Task performance-Use of equip/info-Aircraft control-Pilot cause
Personnel issues-Action/decision-Action-Incorrect action sequence-Pilot cause
Environmental issues-Physical environment-Object/animal/substance-Fence/fence post-Contributed to outcome factor