N1642T accident

NTSB GAA16CA356 · 2016-07-03 · Llano, CA · near CL13

Docket — crew, injuries and powerplant

Summary

The pilot reported that during takeoff from a private dirt airstrip with an air density altitude near 6,100 feet, the airplane became airborne in ground effect, but was not able to "build airspeed sufficient to pitch for Vy (best rate of climb)". The pilot further reported that the wind pushed the airplane over an orchard and he intentionally put the airplane into an aerodynamic stall prior to impacting terrain. A post-impact fire ensued and the airplane was destroyed. The pilot reported that there were no preimpact mechanical failures or malfunctions with the airframe or engine that would have precluded normal operation. The pilot reported that during the takeoff roll he heard a "bang" which he initially assumed to be a rock hitting the fuselage, but later believed to be an engine failure. An examination of the postaccident photographs of the two-bladed propeller showed, approximately 1/3 of the outer portion of one propeller blade was snapped off across the cord perpendicular to the leading edge and the second propeller blade showed "S" bending, torsional twisting, and tip curl, which are all indications consistent with the engine producing power at the time of impact.

Full narrative

The pilot reported that during takeoff from a private dirt airstrip with an air density altitude near 6,100 feet, the airplane became airborne in ground effect, but was not able to "build airspeed sufficient to pitch for Vy (best rate of climb)". The pilot further reported that the wind pushed the airplane over an orchard and he intentionally put the airplane into an aerodynamic stall prior to impacting terrain.

A post-impact fire ensued and the airplane was destroyed.

The pilot reported that there were no preimpact mechanical failures or malfunctions with the airframe or engine that would have precluded normal operation.

The pilot reported that during the takeoff roll he heard a "bang" which he initially assumed to be a rock hitting the fuselage, but later believed to be an engine failure.

An examination of the postaccident photographs of the two-bladed propeller showed, approximately 1/3 of the outer portion of one propeller blade was snapped off across the cord perpendicular to the leading edge and the second propeller blade showed "S" bending, torsional twisting, and tip curl, which are all indications consistent with the engine producing power at the time of impact.

Probable cause

The pilot's failure to attain an adequate airspeed and his intentional aerodynamic stall, which resulted in an impact with terrain and a post-impact fire. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
Minor
Weather conditions
Visual Meteorological Cond
Light condition
Day
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
280
Wind speed (kt)
8
Temperature (F)
97
Nearest airport
BRIAN RANCH
Distance from field
0.0
Airport elevation
3230

Aircraft

RegistrationMakeModelDamageFAR part
N1642T — — DEST 091

Sequence of events

#OccurrencePhase
1 Takeoff Miscellaneous/other Takeoff
2 Takeoff Other weather encounter Takeoff
3 Takeoff Aerodynamic stall/spin defining Takeoff
4 Takeoff Collision with terr/obj (non-CFIT) Takeoff

Findings

Finding
Aircraft-Aircraft oper/perf/capability-Performance/control parameters-Angle of attack-Capability exceeded cause
Aircraft-Aircraft oper/perf/capability-Performance/control parameters-Airspeed-Not attained/maintained cause
Aircraft-Aircraft oper/perf/capability-Performance/control parameters-Climb rate-Not attained/maintained factor
Environmental issues-Conditions/weather/phenomena-Wind-Crosswind-Effect on equipment factor