N3677S accident

NTSB GAA16CA403 · 2016-07-28 · Rexburg, ID · near RXE

Docket — crew, injuries and powerplant

Summary

The student pilot reported that while practicing short-field landings on runway 17, a 4,200 foot asphalt runway, he overshot his intended landing area. He reported that about 65 knots indicated air speed and 25 feet above ground level (AGL), he executed a go-around by applying mixture rich, full throttle, carburetor heat cold, but the electric flaps were left fully extended. He reported that he pulled back on the yoke, but he could not get the airplane to climb, and the airplane descended to the right side of the runway, and touched down in the safety area to the right of the runway and nosed over. The airplane sustained substantial damage to both wings, vertical stabilizer and the rudder. The pilot reported that there were no mechanical malfunctions or anomalies with any portion of the airplane during the flight that would have prevented normal flight operations. Photographs of the accident airplane provided by the Federal Aviation Administration (FAA) showed the airplane inverted with the flaps extended. The airplane manufacturer pilot operating handbook prescribed Balked Landing procedure states: 1. Throttle – Full Open 2. Carburetor Heat – Cold 3. Wing Flaps - 20 Degrees (Immediately) 4. Climb Speed – 55 Knots 5. Wing Flaps 10 Degrees (Until obstacles are cleared) Retract (after reaching a safe altitude and 60 KIAS) The meteorological aerodrome report at accident airport about the time of the accident indicated: The temperature was 90 degrees Fahrenheit, dew point was 37 degrees Fahrenheit, the wind was out of 170 degrees true at 7 knots and varying between 140 degrees and 200 degrees true. The altimeter setting was 30.10. The field elevation at the airport was 4,858 feet and the density altitude was 7,850 feet. According to the FAA Pamphlet 8740-2 pertaining to Density Altitude: Whether due to high altitude, high temperature, or both, reduced air density (reported in terms of density altitude) adversely affects aerodynamic performance and decreases the engine's horsepower output. Takeoff distance, power available (in normally aspirated engines), and climb rate are all adversely affected. Landing distance is affected as well; although the indicated airspeed (IAS) remains the same, the true airspeed (TAS) increases. From the pilot's point of view, therefore, an increase in density altitude results in the following: • Increased takeoff distance. • Reduced rate of climb. • Increased TAS (but same IAS) on approach and landing. According to the aforementioned FAA Pamphlet, the Koch Chart (chart in docket) depicting the relationship between airport temperature (90 degrees) and airport pressure altitude (4,693 feet), the climb rate decreases by 64 percent. The pilot initiated the balked landing procedure at 25 feet AGL.

Full narrative

The student pilot reported that while practicing short-field landings on runway 17, a 4,200 foot asphalt runway, he overshot his intended landing area. He reported that about 65 knots indicated air speed and 25 feet above ground level (AGL), he executed a go-around by applying mixture rich, full throttle, carburetor heat cold, but the electric flaps were left fully extended. He reported that he pulled back on the yoke, but he could not get the airplane to climb, and the airplane descended to the right side of the runway, and touched down in the safety area to the right of the runway and nosed over. The airplane sustained substantial damage to both wings, vertical stabilizer and the rudder.

The pilot reported that there were no mechanical malfunctions or anomalies with any portion of the airplane during the flight that would have prevented normal flight operations.

Photographs of the accident airplane provided by the Federal Aviation Administration (FAA) showed the airplane inverted with the flaps extended.

The airplane manufacturer pilot operating handbook prescribed Balked Landing procedure states:

1. Throttle – Full Open

2. Carburetor Heat – Cold

3. Wing Flaps - 20 Degrees (Immediately)

4. Climb Speed – 55 Knots

5. Wing Flaps 10 Degrees (Until obstacles are cleared) Retract (after reaching a safe altitude and 60 KIAS)

The meteorological aerodrome report at accident airport about the time of the accident indicated: The temperature was 90 degrees Fahrenheit, dew point was 37 degrees Fahrenheit, the wind was out of 170 degrees true at 7 knots and varying between 140 degrees and 200 degrees true. The altimeter setting was 30.10. The field elevation at the airport was 4,858 feet and the density altitude was 7,850 feet.

According to the FAA Pamphlet 8740-2 pertaining to Density Altitude:

Whether due to high altitude, high temperature, or both, reduced air density (reported in terms of density altitude) adversely affects aerodynamic performance and decreases the engine's horsepower output. Takeoff distance, power available (in normally aspirated engines), and climb rate are all adversely affected. Landing distance is affected as well; although the indicated airspeed (IAS) remains the same, the true airspeed (TAS) increases. From the pilot's point of view, therefore, an increase in density altitude results in the following:

• Increased takeoff distance.

• Reduced rate of climb.

• Increased TAS (but same IAS) on approach and landing.

According to the aforementioned FAA Pamphlet, the Koch Chart (chart in docket) depicting the relationship between airport temperature (90 degrees) and airport pressure altitude (4,693 feet), the climb rate decreases by 64 percent. The pilot initiated the balked landing procedure at 25 feet AGL.

Probable cause

The student pilot's failure to retract the flaps during a go-around in high density altitude conditions, resulting in the airplane's inability to climb and a subsequent collision with terrain and nose over. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
170
Wind speed (kt)
7
Temperature (F)
90
Nearest airport
REXBURG-MADISON COUNTY
Distance from field
0.0
Airport elevation
4862

Aircraft

RegistrationMakeModelDamageFAR part
N3677S — — SUBS 091

Sequence of events

#OccurrencePhase
1 Landing Landing area overshoot Cruise
2 Landing Attempted remediation/recovery Cruise
3 Takeoff Collision during takeoff/land defining Takeoff
4 Takeoff Collision with terr/obj (non-CFIT) Takeoff

Findings

Finding
Aircraft-Aircraft oper/perf/capability-Performance/control parameters-Descent rate-Not attained/maintained cause
Personnel issues-Task performance-Use of equip/info-Aircraft control-Student/instructed pilot cause
Personnel issues-Task performance-Use of equip/info-Use of checklist-Student/instructed pilot cause
Personnel issues-Action/decision-Action-Forgotten action/omission-Student/instructed pilot cause
Environmental issues-Conditions/weather/phenomena-Temp/humidity/pressure-High density altitude-Effect on equipment factor