N2601Y accident

NTSB CEN16LA311 · 2016-08-06 · Cardington, OH · near 3OH7

Docket — crew, injuries and powerplant

Summary

The commercial-rated pilot was conducting a local, personal flight and planned to land on a small private grass runway. He reported that he initially planned to land to the east, but he noticed some people on the ground and then chose to maneuver to land to the west. During the landing, the airplane floated and then drifted right, so he decided to go around. He reported that he advanced the throttle full forward and that the airplane felt "anemic" but that the engine gauges appeared normal. At the end of the runway, he rotated for takeoff, and the airplane started to slowly climb; however, the airplane impacted a building just past the end of the runway. A postcrash fire consumed a majority of the airplane. A visual examination of the engine did not reveal any obvious discrepancies; however, fire/thermal damage to the engine prevented a detailed examination. The weather conditions at the time of the accident were conducive to the accumulation of serious carburetor icing at glide power settings. The pilot would have reduced engine power while maneuvering to land, and it is likely that the carburetor accumulated ice at glide power settings, which prevented the production of full engine power during the attempted go-around.

Full narrative

On August 6, 2016, about 1515 eastern daylight time, a Cessna 180E airplane, N2601Y, impacted a building near Cardington, Ohio. The commercial rated pilot received minor injuries and the airplane was destroyed during the accident. The airplane was registered to and operated by a private individual, under the provisions of 14 Code of Federal Regulations Part 91 as a personal flight. Visual meteorological conditions prevailed at the time.

The pilot reported he planned to land on a small (1,950 ft by 40 ft) private grass runway. Initially, he planned to land to the east; however, he noticed some people on the ground and elected to maneuver to land on runway 24. The airplane touched down with the flaps fully extended; the airplane floated and then drifted right, so he decided to go-around. He advanced the throttle to full forward and added that the airplane felt "anemic" but the engine gauges appeared normal. At the end of the runway he rotated for takeoff, and the airplane started to slowly climb. The next thing he remembered was seeing the building in his windscreen.

The airplane impacted a small pole-barn; just past the end of the runway. The pilot managed to exit the airplane, before a post-crash fire engulfed the airplane.

The responding Federal Aviation Administration (FAA) inspector noted that the airplane was destroyed by the impact and post-crash fire, and that the airplane had recent engine work done. The pilot, who was also an aircraft mechanic, reported that the engine had accumulated about 2 hours since a top overhaul. A visual inspection of the engine did not note any obvious discrepancies; however, fire/thermal damage to the engine prevented a detailed examination.

The carburetor icing probability chart included in Federal Aviation Administration Special Airworthiness Information Bulletin No. CE-09-35, Carburetor Icing Prevention, indicated that the airplane was operating in an area that was associated with a serious risk of carburetor ice formation at glide power settings.

Probable cause

The partial loss of engine power due to carburetor icing during an attempted go-around. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
Minor
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
OVC
Ceiling (ft)
6000
Visibility (sm)
10
Wind direction
360
Wind speed (kt)
10
Temperature (F)
82
Nearest airport
My Place Airport
Distance from field
0.0
Airport elevation
975

Aircraft

RegistrationMakeModelDamageFAR part
N2601Y — — DEST 091

Sequence of events

#OccurrencePhase
1 Landing-aborted after touchdown Attempted remediation/recovery Cruise
2 Landing-aborted after touchdown Fuel related Cruise
3 Landing-aborted after touchdown Loss of engine power (partial) Cruise
4 Landing-aborted after touchdown Collision during takeoff/land defining Cruise

Findings

Finding
Environmental issues-Conditions/weather/phenomena-Temp/humidity/pressure-Conducive to carburetor icing-Effect on equipment cause