N91488 accident

NTSB CEN16LA354 · 2016-08-29 · Monett, MO · near HFJ

Docket — crew, injuries and powerplant

Summary

The commercial pilot stated that, during the landing roll following a normal landing, the airplane began pulling to the right. The airplane departed the right side of the runway and traveled down an embankment and through a barbed wire fence. When the pilot inspected the airplane, he noted that the right main landing gear (MLG) had collapsed. An examination of the landing gear found that the locking mechanism had been improperly rigged. Several weeks before the accident, the airplane's right MLG was damaged in an incident and had been replaced with a serviceable unit. A review of maintenance records noted that a gear retraction test was conducted after the replacement and described as satisfactory. It is likely that during this maintenance, the landing gear was improperly rigged, which resulted in its collapse on the accident flight.

Full narrative

On August 29, 2016, about 0930 central daylight time, a North American Navion airplane, N91488, departed off the side of the runway at the Monett Regional Airport (KHFJ), Monett, Missouri. The pilot was not injured and the airplane was substantially damaged. The airplane was registered to and operated by a private individual under the provisions of 14 Code of Federal Regulations Part 91 as a personal flight. Visual meteorological conditions prevailed for the flight, which operated without a flight plan. The flight originated from the Gimlin Airport (18MO), Ozark, Missouri, and was landing at KHFJ.According to the pilot, he landed the airplane on runway 18 at KHFJ about 0930. Weather was clear and he estimated the wind at 120° at 4 knots. Following a normal approached and landing, he noticed the airplane's right wing was lower than the left wing, and the airplane began a pull to the right. The airplane departed the right side of the runway, went down an embankment and run through a barbed wire fence. When the pilot inspected the airplane, he noted that the right main landing gear (MLG) had collapsed. During recovery of the airplane, the airplane was lifted and the right MLG was extended manually and locked.

The airplane was examined by inspectors from the Federal Aviation Administration. A landing gear swing test was conducted and the landing gear had been improperly rigged. A review of the airplane's history revealed that several weeks prior to the accident, the airplane's right MLG scissor was damaged during a high speed turn.

A review of maintenance records revealed that on July 22, 2016, the airplane's right MLG scissor was replaced with a serviceable unit. A gear retraction test was conducted and described as satisfactory.

Probable cause

Maintenance personnel’s failure to properly rig the right main landing gear locking mechanism, which resulted in a gear collapse during landing. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
120
Wind speed (kt)
5
Temperature (F)
81
Nearest airport
MONETT RGNL
Distance from field
0.0
Airport elevation
1313

Aircraft

RegistrationMakeModelDamageFAR part
N91488 — — SUBS 091

Sequence of events

#OccurrencePhase
1 Landing-landing roll Landing gear collapse defining Cruise
2 Landing-landing roll Loss of control on ground Cruise
3 Landing-landing roll Runway excursion Cruise
4 Landing-landing roll Collision with terr/obj (non-CFIT) Cruise

Findings

Finding
Aircraft-Aircraft systems-Landing gear system-Gear extension and retract sys-Incorrect service/maintenance cause
Personnel issues-Task performance-Maintenance-(general)-Maintenance personnel cause