N15MD accident

NTSB CEN16CA359 · 2016-08-26 · Wichita Falls, TX · near CWC

Docket — crew, injuries and powerplant

Summary

The pilot reported that, during a maintenance test flight, when the airplane reached rotation speed on takeoff, he applied elevator control to rotate. The elevator control could not be moved sufficiently aft for rotation and liftoff, and the pilot aborted the takeoff. During the aborted takeoff, the airplane travelled off the departure end of the runway and came to a stop on an airport access road. The airplane's left main landing gear collapsed and the left wing was bent during the accident. The pilot reported that he had performed a control system check prior to the flight and that the controls functioned normally during that check. Examination of the airplane revealed that the elevator control operated normally after the accident, but further examination revealed that a plastic elbow fitting for the windshield defroster duct was loose and could be rotated into a position that obstructed full motion of the control yoke. Examination of the elbow revealed that it was not an approved part and appeared to be the type of plastic elbow found in home supply stores. The recent maintenance performed was not in the area where the plastic elbow was located.

Full narrative

The pilot reported that, during a maintenance test flight, when the airplane reached rotation speed on takeoff, he applied elevator control to rotate. The elevator control could not be moved sufficiently aft for rotation and liftoff, and the pilot aborted the takeoff. During the aborted takeoff, the airplane travelled off the departure end of the runway and came to a stop on an airport access road. The airplane's left main landing gear collapsed and the left wing was bent during the accident. The pilot reported that he had performed a control system check prior to the flight and that the controls functioned normally during that check. Examination of the airplane revealed that the elevator control operated normally after the accident, but further examination revealed that a plastic elbow fitting for the windshield defroster duct was loose and could be rotated into a position that obstructed full motion of the control yoke. Examination of the elbow revealed that it was not an approved part and appeared to be the type of plastic elbow found in home supply stores. The recent maintenance performed was not in the area where the plastic elbow was located.

Probable cause

The incorrect maintenance of the airplane's ventilation system which resulted in an obstruction of the elevator control system. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
120
Wind speed (kt)
6
Temperature (F)
79
Nearest airport
KICKAPOO DOWNTOWN
Distance from field
8.0
Airport elevation
1003

Aircraft

RegistrationMakeModelDamageFAR part
N15MD — — SUBS 091

Sequence of events

#OccurrencePhase
1 Takeoff Flight control sys malf/fail defining Takeoff
2 Takeoff-rejected takeoff Collision with terr/obj (non-CFIT) Takeoff

Findings

Finding
Aircraft-Aircraft systems-Flight control system-Elevator control system-Inoperative cause
Aircraft-Aircraft systems-Air conditioning system-Air distribution system-Incorrect service/maintenance cause