N1157N accident

NTSB GAA17CA211 · 2017-04-28 · Cedar Key, FL · near CDK

Docket — crew, injuries and powerplant

Summary

The private pilot reported that, during the landing roll, he had traveled about halfway down the 2,355 ft-long runway when he realized that a go-around was going to be required. He could not recall the airplane's airspeed when the airplane touched down on the runway that was located steps from the ocean. However, he did recall that he initiated the go-around by applying full throttle, retracting the flaps to 0, and rotating at 62 knots. The airplane "lifted off but did not gain altitude." The pilot lowered the nose to accelerate, but the airplane stalled and impacted the water. The airplane sustained substantial damage to the right wing spar and aileron. According to the manufacturer's Pilot's Operating Handbook, the go-around procedure is: CAUTION         To minimize control wheel forces during go-around, timely nose-down trimming is recommended to counteract nose up pitching moment as power is increased and/or flap retraction.         Power…..Full Throttle/2700 RPM         Mixture…..Full Rich         Airspeed…..65 KIAS         Wing Flaps…..Takeoff position after climb established         Trim…..Nose Down (to reduce control forces)         Airspeed…..Accelerate to 76 KIAS         Landing Gear…..-Retract         Wing Flaps…..Retract         Cowl Flaps…..Open         Airspeed…..Accelerate to 86 KIAS The pilot reported that there were no preaccident mechanical malfunctions or failures with the airplane that would have precluded normal operation.

Full narrative

The private pilot reported that during the landing roll, he had traveled about half of the distance down the 2,355 ft. runway and he realized that a go-around was going to be required. He could not recall the airplane's airspeed when the airplane touched down on the runway that was located steps from the ocean. However, he did recall that he initiated the go-around by applying full throttle, retracting the flaps to zero and rotating at 62 kts. The airplane "lifted off but did not gain altitude." The pilot lowered the nose to accelerate, but the airplane stalled abd impacted the water. The airplane sustained substantial damage to the right wing spar and aileron.

According to the manufacturer's pilot operating handbook, the go-around procedure is:

CAUTION

To minimize control wheel forces during go-around, timely nose-down trimming is recommended to counteract nose up pitching moment as power is increased and/ or flap retraction.

Power….. Full Throttle/2700 RPM

Mixture….. Full Rich

Airspeed….. 65 KIAS

Wing Flaps….. Takeoff position after climb established

Trim….. Nose Down (to reduce control forces)

Airspeed….. Accelerate to 76 KIAS

Landing Gear….. Retract

Wing Flaps….. Retract

Cowl Flaps….. Open

Airspeed….. Accelerate to 86 KIAS

The pilot reported that there were no preaccident mechanical malfunctions or failures with the airplane that would have precluded normal operation.

Probable cause

The pilot’s failure to follow the manufacturer’s go-around procedure, which resulted in an aerodynamic stall. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
280
Wind speed (kt)
10
Temperature (F)
81
Nearest airport
GEORGE T LEWIS
Distance from field
0.0
Airport elevation
11

Aircraft

RegistrationMakeModelDamageFAR part
N1157N — — SUBS 091

Sequence of events

#OccurrencePhase
1 Landing-landing roll Attempted remediation/recovery Cruise
2 Landing-aborted after touchdown Collision during takeoff/land defining Cruise

Findings

Finding
Personnel issues-Task performance-Use of equip/info-Aircraft control-Pilot cause
Personnel issues-Task performance-Use of equip/info-Use of policy/procedure-Pilot cause
Aircraft-Aircraft oper/perf/capability-Performance/control parameters-Airspeed-Not attained/maintained cause
Aircraft-Aircraft oper/perf/capability-Performance/control parameters-Climb rate-Not attained/maintained factor
Aircraft-Aircraft oper/perf/capability-Performance/control parameters-Configuration-Incorrect use/operation factor