N173LL accident

NTSB GAA17CA268 · 2017-05-03 · Kaunakakai, HI · near MKK

Docket — crew, injuries and powerplant

Summary

The student pilot reported that she was practicing touch-and-go landings on an asphalt runway. She initiated an approach and bounced the landing and then she initiated a go-around. She was airborne when she pushed the carb heat in and applied full throttle "but mistakenly put flaps up, all at once." The airplane descended to the runway and landed hard. During the landing roll, she pulled the throttle back to idle, gained her bearings, and then initiated a takeoff. She noticed a binding and restriction in the elevator and yoke control movements while remaining in the airport's pattern. She declared an emergency and landed the airplane on the runway. The airplane sustained substantial damage to the elevator control column. The manufacturer's Pilot's Operating Handbook identified the Balked Landing procedure as: 1. Throttle – Full Open 2. Carburetor Heat – Cold 3. Wing Flaps –20° (Immediately) 4. Climb Speed – 55 KIAS 5. Wing Flaps – 10° (Until obstacles are cleared) Retract (After reaching a safe altitude and 60 KIAS) The student reported that there were no preaccident mechanical malfunctions or failures with the airplane that would have precluded normal operation.

Full narrative

The student pilot reported that she was practicing touch and go landings to an asphalt runway. She initiated an approach and bounced the landing, then she accomplished a go-around. However, she was airborne when she pushed the carb heat in and applied full throttle, "but mistakenly put flaps up, all at once." The airplane descended to the runway and landed hard. During the landing roll, she pulled the throttle back to idle and gained her bearings, then she initiated a takeoff. She noticed a binding and restriction in the elevator and yoke control movements while remaining in the airport's pattern. She declared an emergency and landed the airplane on the runway. The airplane sustained substantial damage to the elevator control column.

The manufacturer's pilot operating handbook identifies the Balked Landing procedure as:

1. Throttle – Full Open

2. Carburetor Heat – Cold

3. Wing Flaps –20° (Immediately)

4. Climb Speed – 55 KIAS

5. Wing Flaps – 10° (Until obstacles are cleared) Retract (After reaching a safe altitude and 60 KIAS)

The pilot reported that there were no preaccident mechanical malfunctions or failures with the airplane that would have precluded normal operation.

Probable cause

The student pilot’s incorrect flap configuration during the go-around, which resulted in a hard, forced landing. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
20
Wind speed (kt)
9
Temperature (F)
81
Nearest airport
MOLOKAI
Distance from field
0.0
Airport elevation
453

Aircraft

RegistrationMakeModelDamageFAR part
N173LL — — SUBS 091

Sequence of events

#OccurrencePhase
1 Takeoff-rejected takeoff Abnormal runway contact defining Takeoff
2 Landing-flare/touchdown Hard landing Cruise

Findings

Finding
Aircraft-Aircraft oper/perf/capability-Performance/control parameters-Configuration-Incorrect use/operation cause
Aircraft-Aircraft systems-Flight control system-TE flap control system-Incorrect use/operation cause
Personnel issues-Task performance-Use of equip/info-Use of equip/system-Student/instructed pilot cause