N165AB accident

NTSB CEN17LA312 · 2017-08-03 · Danville, AR · near 32A

Docket — crew, injuries and powerplant

Summary

The noncertificated pilot, who was the owner of the experimental weight shift control aircraft, stated that he was practicing a series of takeoff and landings called "crow hops" when the left main landing gear tire separated from the wheel rim. The aircraft then veered off the runway and rolled onto its side. The pilot stated that the previous airplane owner had put liquid fix-a-flat in the left tire, which is a product not to be used in aircraft tires. The pilot said that liquid fix a flat will corrode the aluminum of the landing gear wheels and allowed the tire to spin on the wheel during braking. Postaccident examination of the airplane revealed the presence of liquid flat repair called "slime," and that the diameter of the main landing gear wheel was relatively small compared to the tire, which likely resulted in slippage of the tire from the wheel.

Full narrative

On August 3, 2017, at 1200 central daylight time, an experimental amateur-built Ralph Marine Devil Dog, N165AB, veered off the runway and impacted terrain during landing at Danville Municipal Airport (32A), Danville, Arkansas. The airplane sustained substantial damage. The uncertificated pilot was uninjured. The airplane was operated by the pilot and registered to the previous owner under 14 Code of Federal Regulations Part 91 as a personal flight that was not operating on a flight plan. The local flight originated from and was to remain at 32A.

The pilot recently purchased the airplane, which was a tricycle, weight-shift control aircraft, that had a 40 mile per hour lift-off speed. The pilot stated that he was practicing takeoffs and landings, which he called "crow hops," on the runway. The pilot intended to fly the airplane along the runway but not enter the airport traffic pattern. He performed four crow hops and during the last landing, the left main landing gear tire became flat and separated from its wheel at a speed of 30 miles per hour. The airplane veered right off the runway surface and into a grass area. The airplane rolled over onto its left side damaging the airplane mast.

The pilot stated that the previous airplane owner had put liquid fix-a-flat, which was a product not to be used in aircraft tires, in the left main landing gear wheel. The pilot stated that the liquid fix-a-flat will corrode the aluminum landing gear wheels and would allow the tire to spin on the wheel during braking.

Post-accident examination of the airplane by a Federal Aviation Administration inspector revealed the presence of a liquid flat repair substance commonly called "slime" in the left main landing gear wheel and around the inner edges of the tire. The inspector also stated that the diameter of the main landing gear wheel was relatively small compared to the tire.

Probable cause

A separation of the left tire from its wheel because of the use of an improper substance and wheel size, which resulted in a loss of directional control during landing. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
0
Temperature (F)
82
Nearest airport
Danville Municipal Airport
Distance from field
0.0
Airport elevation
393

Aircraft

RegistrationMakeModelDamageFAR part
N165AB — — SUBS 091

Sequence of events

#OccurrencePhase
1 Prior to flight Aircraft maintenance event Standing
2 Takeoff Part(s) separation from AC defining Takeoff
3 Takeoff-rejected takeoff Attempted remediation/recovery Takeoff
4 Landing-landing roll Loss of control on ground Cruise
5 Landing-landing roll Collision with terr/obj (non-CFIT) Cruise

Findings

Finding
Aircraft-Aircraft systems-Landing gear system-Wheel/ski/float-Incorrect service/maintenance cause