N5381F Piper PA 28R accident

NTSB GAA18CA053 · 2017-11-16 · Melborne, FL · near MLB

Docket — crew, injuries and powerplant

Summary

According to the pilot, during an approach in the rain, there were wind gusts, and he retracted the flaps to zero. He noted that, "I decided to land a little faster than the preferred 75-80 mph." The pilot reported that the airplane "did not settle into a normal rollout." He recalled that a few seconds into the landing roll, the airplane veered to the left and exited the left side of the runway. The airplane continued across the safety area and collided with a drainage culvert. The airplane sustained substantial damage to the engine mounts. Photographs provided by the Federal Aviation Administration aviation safety inspector showed three parallel rubber skid markings that began about 1,500 ft from the approach end of the runway. The markings began in the center of the runway and exhibited a sharp left turn that continued along a path through the safety area and stopped at the drainage culvert. The pilot reported that the left main landing gear assembly and tire failed during the landing roll. However, an examination of the landing gear assembly, wheel, and tire revealed that there were no mechanical anomalies or failures before the runway excursion. The METAR at the accident airport reported that, about the time of the accident, the rain was light, and the wind was from 010° at 12 knots.

Full narrative

According to the pilot, during an approach in the rain, there were wind gusts and he retracted the flaps to zero. He noted that, "I decided to land a little faster than the preferred 75-80 mph."

The pilot reported that the airplane, "did not settle into a normal rollout." He recalled that a few seconds into the landing roll, the airplane veered to the left and exited the left side of the runway. The airplane continued across the safety area and collided with a drainage culvert.

Photographs provided by the Federal Aviation Administration (FAA), Aviation Safety Inspector assigned to the accident, revealed three parallel rubber skid markings that began about1,500ft from the approach end of runway 9R. The markings began in the center of the runway and exhibited a sharp left turn that continued along a path through the safety area and stopped at the drainage culvert.

The pilot reported that the left main landing gear assembly and tire failed during the landing roll.

However, an examination of the landing gear assembly, and the wheel and tire, by the FAA Maintenance Inspector, identified that there were no anomalies or failures prior to the runway excursion.

The METAR at the accident airport reported that about the time of the accident, the rain was light, and the wind was from 010° at 12kts.

The airplane sustained substantial damage to the engine mounts.

Probable cause

The pilot’s loss of directional control during the landing roll on the wet runway. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
OVC
Ceiling (ft)
3900
Visibility (sm)
4
Wind direction
10
Wind speed (kt)
12
Temperature (F)
70
Nearest airport
MELBOURNE INTL
Distance from field
0.0
Airport elevation
33

Aircraft

RegistrationMakeModelDamageFAR part
N5381F PIPER PA 28R SUBS 091

Sequence of events

#OccurrencePhase
1 Approach-VFR pattern final Other weather encounter Cruise
2 Landing Loss of control on ground defining Cruise
3 Landing Runway excursion Cruise
4 Landing Collision with terr/obj (non-CFIT) Cruise

Findings

Finding
Personnel issues-Task performance-Use of equip/info-Aircraft control-Pilot cause
Aircraft-Aircraft oper/perf/capability-Performance/control parameters-Directional control-Attain/maintain not possible cause
Environmental issues-Physical environment-Runway/land/takeoff/taxi surface-Wet surface-Effect on operation factor