N944DC Robinson R44 accident

NTSB GAA18CA430 · 2018-07-09 · Okawville, IL

Docket — crew, injuries and powerplant

Summary

The helicopter pilot reported that, before starting agricultural application flights for the day, he calculated that about 490 lbs of chemical would bring the helicopter's weight near the manufacturer's maximum gross weight limitation. After an agricultural application flight, he landed the helicopter on a platform on top of a chemical reloading truck and reloaded the chemical tank with the precalculated amount. Once reloaded, he maintained a stabilized hover over the truck and transitioned to forward flight. When the helicopter cleared the truck, the "engine [made] a lower sound," and the main rotor low rpm horn activated, and the caution light illuminated. He immediately added power, lowered the collective to restore main rotor rpm, and pitched forward to gain airspeed, but the helicopter would not climb. He then decided to perform a roll-on landing on the adjacent field, but the helicopter landed hard. The helicopter sustained substantial damage to the tail cone, tail rotor blades, and fuselage. The pilot reported that there were no preaccident mechanical failures or malfunctions with the helicopter that would have precluded normal operation. The pilot added that, after the accident, he recalculated the helicopter's weight and balance. He determined that, during the reloading operation, the chemical tank was not empty but had about 80 lbs of chemical remaining and that the added precalculated amount of chemical exceeded the helicopter's maximum gross weight limitation.

Full narrative

The helicopter pilot reported that, before starting aerial application flights for the day, he calculated that about 490 pounds of chemical would bring the helicopter's weight near the manufacturer's maximum gross weight limitation.

After an aerial application flight, he landed on a platform located on top of a chemical reloading truck and reloaded the chemical tank with the pre-calculated amount. Once reloaded, he maintained a stabilized hover over the truck and transitioned to forward flight. When the helicopter cleared the truck, the "engine [made] a lower sound" and the main rotor low revolutions per minute (RPM) horn activated and the caution light illuminated. He immediately added power, lowered the collective to restore main rotor RPM, and pitched forward to gain airspeed but the helicopter would not climb. He then decided to perform a roll-on landing on the adjacent field, but the helicopter landed hard.

The helicopter sustained substantial damage to the tail cone, tail rotor blades, and fuselage.

The pilot reported that there were no preaccident mechanical failures or malfunctions with the helicopter that would have precluded normal operation.

The pilot added that after the accident, he recalculated the helicopter's weight and balance. He determined that during the reloading operation, the chemical tank was not empty with about 80 pounds of chemical remaining and the added precalculated amount of chemical exceeded the maximum gross weight limitation.

Probable cause

The pilot's improper preflight weight and balance calculation, which resulted in his operating the helicopter over its maximum gross takeoff weight and in its subsequent failure to climb.   The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
70
Wind speed (kt)
4
Temperature (F)
86
Distance from field
0.0

Aircraft

RegistrationMakeModelDamageFAR part
N944DC Robinson R44 SUBS 137

Sequence of events

#OccurrencePhase
1 Prior to flight Preflight or dispatch event Standing
2 Takeoff Settling with power/vortex ring state defining Takeoff
3 Takeoff Attempted remediation/recovery Takeoff
4 Takeoff Collision with terr/obj (non-CFIT) Takeoff

Findings

Finding
Aircraft-Aircraft oper/perf/capability-Aircraft capability-Maximum weight-Capability exceeded cause
Personnel issues-Task performance-Planning/preparation-Weight/balance calculations-Pilot factor
Personnel issues-Task performance-Inspection-(general)-Pilot factor