N6674Y Beech 55 accident

NTSB GAA19CA011 · 2018-10-05 · San Antonio, TX · near SAT

Docket — crew, injuries and powerplant

Summary

The pilot reported that, the day before the accident flight, he had flown the airplane and wanted to become more comfortable with new instruments that had been installed. So, after the flight, while in a hangar, he and a friend turned the airplane's electrical power on to familiarize the pilot with the autopilot system and specifically with how it would follow heading bug settings. During the familiarization, they "ran the [pitch] trim all the way up." The pilot added that, before takeoff for the accident flight, he did not check the pitch trim setting because he believed it would be the same as his previous flight, instead of the pitch trim setting after his autopilot ground familiarization. He added that, during takeoff, the nose pitched up severely. He lowered the nose, and the airplane entered a negative G condition. He realized that he "did not latch the seat belt very good" and saw that his seatbelt had disconnected and that he was no longer in his seat and could not regain airplane control. The airplane struck the runway, porpoised, and the nose landing gear collapsed. The airplane skidded and struck a taxiway light. Postaccident examination of the airplane revealed that the vertical trim tab was in the full-down position, indicating that full nose-up trim was applied. The airplane sustained substantial damage to both engines and the fuselage. The pilot reported that there were no preaccident mechanical failures or malfunctions with the airplane that would have precluded normal operation. The Pilot's Operating Handbook checklist titled, "Before Takeoff," stated: Seat Belts and Shoulder Harnesses – CHECK… 15. Trim – AS REQUIRED FOR TAKE-OFF

Full narrative

The pilot reported that, the day before the accident flight, he had flown the airplane, and wanted to become more comfortable with the new instruments which had been installed. So, after the flight, while in a hangar, he and a friend turned the airplane's electrical power on to familiarize the pilot with the autopilot system, and specifically how it would follow heading bug settings. During the familiarization, they "ran the [pitch] trim all the way up".

The pilot added that, during the accident flight, before takeoff, he did not check the pitch trim setting because he believed it would be the same as his previous flight, instead of the pitch trim setting after his autopilot ground familiarization. He added that, during takeoff, the nose pitched up severely. He lowered the nose, entered a negative G condition, discovered that he "did not latch the seat belt very good" and observed his seat belt had disconnected, and he was no longer in his seat and could not regain airplane control. The airplane struck the runway, porpoised, and on the third cycle, the nose landing gear collapsed. The airplane skidded and struck a taxiway light.

Postaccident examination of the airplane revealed that the vertical trim tab was in the "full down position," indicating that full nose-up trim was applied.

The airplane sustained substantial damage to the both engines and fuselage.

The pilot reported that there were no preaccident mechanical failures or malfunctions with the airplane that would have precluded normal operation.

The pilot operating handbook checklist titled "Before Takeoff" stated:

1. Seat Belts and Shoulder Harnesses – CHECK

It continued:

15. Trim – AS REQUIRED FOR TAKE-OFF

Probable cause

The pilot's improper takeoff trim setting and failure to properly secure his seatbelt, which resulted in a loss of airplane control. Contributing to the accident was the pilot's failure to follow the Before Takeoff checklist. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
Minor
Weather conditions
Visual Meteorological Cond
Light condition
Day
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
140
Wind speed (kt)
9
Temperature (F)
84
Nearest airport
SAN ANTONIO INTL
Distance from field
1.0
Airport elevation
809

Aircraft

RegistrationMakeModelDamageFAR part
N6674Y Beech 55 SUBS 091

Sequence of events

#OccurrencePhase
1 Prior to flight Miscellaneous/other Standing
2 Takeoff Abrupt maneuver defining Takeoff
3 Takeoff Abnormal runway contact Takeoff
4 Takeoff Landing gear collapse Takeoff
5 Takeoff Collision with terr/obj (non-CFIT) Takeoff

Findings

Finding
Aircraft-Aircraft systems-Flight control system-Elevator tab control system-Incorrect use/operation cause
Aircraft-Aircraft systems-Equipment/furnishings-Flight compartment equipment-Incorrect use/operation cause
Personnel issues-Task performance-Use of equip/info-Aircraft control-Pilot cause
Personnel issues-Psychological-Attention/monitoring-Task monitoring/vigilance-Pilot cause
Aircraft-Aircraft oper/perf/capability-Performance/control parameters-Pitch control-Attain/maintain not possible cause
Personnel issues-Task performance-Use of equip/info-Use of checklist-Pilot - F cause
Environmental issues-Physical environment-Object/animal/substance-Runway/taxi/approach light-Contributed to outcome factor