N488VG Just JUST AIRCRAFT (HIGHL accident

NTSB GAA19CA034 · 2018-10-12 · Monroe, WA

Docket — crew, injuries and powerplant

Summary

The pilot of the tailwheel-equipped, experimental, amateur-built airplane, who was also an airframe and powerplant mechanic, reported that, during approach to a sandbar, he side-slipped the airplane and that the engine then lost power because he was "too aggressive with the throttle and pulled it enough to bend the [carburetor] idle stop screw bracket." The engine was normally quiet, the airplane was sound proofed, and the pilot also used a noise-cancelling headset, which prevented him from being aware of the power loss until he attempted to add power to no avail. He did not have enough time to restart the engine, so the airplane settled onto the water about 15 to 20 ft short of the sandbar. Subsequently, the airplane hydroplaned and then came to rest on the sandbar inverted. The pilot reported that the reason he was aggressive with the throttle was because of a lean mixture that tended to overheat the engine during takeoff or cruise on hot days. The airplane sustained substantial damage to the left wing lift strut, left wing, and rudder. The pilot reported that there were no preaccident mechanical failures or malfunctions with the airplane that would have precluded normal operation. The Federal Aviation Administration inspector reported that the pilot had modified the number and position of the last hole in the fuel spray bar. By doing so, the pilot was able to get the engine to "barely run" to perform short-field landings. During the accident landing, it "must have cut off the flow of fuel enough to make the engine quit." That pilot reported that he had previously attempted to mechanically enrich the mixture by drilling holes in the fuel spray bar but had drilled a hole "at the location where the engine wanted to idle," meaning that, if the hole was open, the engine would idle high, and if the hole was closed, the engine would "die." He added that it was not a problem unless he was trying to land short.    

Full narrative

The pilot of the tailwheel-equipped, experimental amateur built airplane, who was also an airframe and powerplant mechanic reported that, during approach to a sandbar, he side-slipped the airplane and the engine lost power because he was "too aggressive with the throttle and pulled it enough to bend the [carburetor] idle stop screw bracket." Because the engine was normally quiet, the airplane was sound proofed, and he used a noise-cancelling headset, he was unaware of the power loss until he attempted to add power, to no avail. He did not have enough time to restart the engine, so the airplane settled onto the water about 15 to 20 ft short of the sandbar. Subsequently, the airplane hydroplaned and came to rest on the sandbar inverted.

The pilot reported that the reason he was aggressive with the throttle was because of a lean mixture that tended to overheat the engine during takeoff or cruise on hot days.

Previously, he had attempted to mechanically enrichen the mixture by drilling holes in the fuel spray bar, but had drilled a hole "at the location where the engine wanted to idle", meaning that if the hole was open, the engine would idle high and if the hole was closed, the engine would "die." He added that it was not a problem unless he was trying to land short.

The airplane sustained substantial damage to the left wing lift strut, left wing, and rudder.

The pilot reported that there were no preaccident mechanical failures or malfunctions with the airplane that would have precluded normal operation.

The Federal Aviation Administration (FAA) inspector reported that the pilot had modified the number and position of the last hole in the fuel spray bar. By doing so, the pilot was able to get the engine to "barely run" to perform short field landings. During the accident landing, it "must have cut off the flow of fuel enough to make the engine quit."

Probable cause

The pilot's improper engine modification and operation, which resulted in a total loss of engine power due to fuel starvation, and the pilot's failure to maintain an adequate approach path, which resulted in the airplane landing short of the runway. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
BKN
Ceiling (ft)
4900
Visibility (sm)
10
Wind direction
0
Temperature (F)
52
Distance from field
0.0

Aircraft

RegistrationMakeModelDamageFAR part
N488VG Just JUST AIRCRAFT (HIGHL SUBS 091

Sequence of events

#OccurrencePhase
1 Approach-VFR pattern final Fuel starvation defining Cruise
2 Approach-VFR pattern final Loss of engine power (total) Cruise
3 Landing Roll over Cruise

Findings

Finding
Aircraft-Aircraft oper/perf/capability-Performance/control parameters-Descent/approach/glide path-Not attained/maintained cause
Personnel issues-Task performance-Maintenance-Modification/alteration-Pilot cause
Personnel issues-Task performance-Use of equip/info-Use of equip/system-Pilot cause
Aircraft-Fluids/misc hardware-Fluids-Fuel-Not specified cause
Environmental issues-Physical environment-Runway/land/takeoff/taxi surface-Wet surface-Contributed to outcome factor