N2920Q Piper PA32R accident

NTSB WPR19LA011 · 2018-10-21 · Indianapolis, IN

Docket — crew, injuries and powerplant

Summary

The pilot reported that he was approaching his destination airport at 1,000 ft above ground level when the engine lost total power. After an unsuccessful attempt to restart the engine, the pilot performed a forced landing to a nearby parking lot, during which the airplane sustained substantial damage. A postaccident examination of the engine revealed that the single-drive dual magneto failed to produce spark due to the displacement of its camshaft. As a result, when the camshaft was positioned to neutral, the contact points were opened instead of closed, and when the camshaft was rotated approximately 8°, the points were closed when they should have been open. The magneto was then re-assembled to manufacturer specifications, tested, and found to produce spark on all ignition leads. The displacement of the camshaft resulted in the magneto not producing spark on any of its ignition leads, and a subsequent loss of engine power. It could not be determined if the displacement of the magneto camshaft was a result of an improper installation or if it moved in flight.

Full narrative

On October 21, 2018, at 1444 eastern daylight time, a Piper PA-32R-300 airplane, N2920Q, was substantially damaged when it was involved in an accident near Indianapolis, Indiana. The pilot was not injured. The airplane was operated as a Title 14 Code of Federal Regulations (CFR) Part 91 personal flight. The pilot reported that he was about 4 miles north of his destination airport, at 1,000 ft above ground level (agl), when the engine experienced a complete loss of power. He attempted to restart the engine, but was unsuccessful, and chose to perform a forced landing in a parking lot. During the landing roll, the airplane struck a curb, and the wing impacted a tree.

During examination of the engine, a Federal Aviation Administration (FAA) inspector manually rotated the single-drive dual magneto drive shaft, and the magneto failed to produce spark on any of its leads. Review of maintenance logbooks revealed that the magneto was overhauled and tested on February 8, 2018 and had accumulated 87 hours since the overhaul.

The magneto was examined and tested, during which the impulse coupling was rotated by hand and the magneto timing was tested using a timing light. When the impulse coupling was rotated to neutral position, contact points were open when they should have been closed. When impulse coupling was rotated counterclockwise about 8° to the L mark, the timing light indicated that contact points were closed when they should have been open. The magneto camshaft was displaced when viewed through magneto timing port. When the cam was positioned to neutral, the points were opened instead of being closed. When the camshaft was rotated approximately 8°, the points should have opened, but they closed at that position. Such displacement of the camshaft would cause the magneto not to produce spark. The magneto was disassembled, inspected, and reassembled, with the cam shaft installed per the manufacturer’s specifications, and when subsequently tested, it produced sparks on all leads.

Probable cause

A total loss of engine power due to displacement of the dual magneto’s internal camshaft, which resulted in the magneto’s inability to produce spark.  The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
0
Temperature (F)
50
Distance from field
0.0

Aircraft

RegistrationMakeModelDamageFAR part
N2920Q Piper PA32R SUBS 091

Sequence of events

#OccurrencePhase
1 Enroute-cruise Loss of engine power (total) defining Climb
2 Landing-landing roll Collision with terr/obj (non-CFIT) Cruise

Findings

Finding
Aircraft-Aircraft power plant-Ignition system-Magneto/distributor-Inoperative cause