N173MS Bell 206 accident

NTSB GAA19CA209 · 2019-04-12 · Big Pine, FL

Docket — crew, injuries and powerplant

Summary

The pilot reported that, after the fourth aerial application flight of the day, he landed and positioned the helicopter near the autoloader boom truck. He reduced engine power to flight idle, and the ground crew began the loading process. He verified that the collective position was full down and the cyclic friction was on, and he then exited the helicopter to stretch while maintaining one hand on the cyclic. The pilot reported that, immediately after, while standing next to the helicopter, he heard two "loud bangs." He immediately boarded the helicopter, the ground crew secured the truck's boom, and the pilot shut down the engine. Examination revealed that a main rotor blade had struck the truck's boom arm and that the main rotor blades sustained substantial damage. The director of aerial operations reported that there were no preaccident mechanical failures or malfunctions with the helicopter that would have precluded normal operation.

Full narrative

The helicopter pilot reported that, after the fourth aerial application flight of the day, he landed and positioned the helicopter near the autoloader boom truck. He reduced engine power to flight idle and the ground crew began the loading process. He verified the collective position was full down, set the cyclic friction to ON, and exited the helicopter to stretch while maintaining one hand on the cyclic. Immediately after, while standing next to the helicopter, he heard two "loud bangs." He immediately boarded the helicopter; the ground crew secured the boom, and the pilot shut down the engine.

Upon further examination by the operator's maintenance personnel, it was determined that a main rotor blade struck the boom arm and that the main rotor blades were beyond the repair limitations, per the manufacturer's guidance.

The helicopter sustained substantial damage to the main rotor blades.

The director of aerial operations reported that there were no preaccident mechanical failures or malfunctions with the airplane that would have precluded normal operation.

The director of aerial operations added that, at the site of the accident, the wind was 130º at 11 knots, gusting up to 19 knots. The helicopter was oriented with a southbound heading.

Probable cause

The pilot's failure to maintain helicopter control while it was being reloaded with the rotors turning in gusting wind conditions, which resulted in a rotor strike with ground equipment. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
130
Wind speed (kt)
9
Temperature (F)
88
Distance from field
0.0

Aircraft

RegistrationMakeModelDamageFAR part
N173MS Bell 206 SUBS PUBU

Sequence of events

#OccurrencePhase
1 Standing-engine(s) operating Loss of control on ground defining Standing
2 Standing-engine(s) operating Collision with terr/obj (non-CFIT) Standing
3 Standing-engine(s) operating Aircraft servicing event Standing

Findings

Finding
Personnel issues-Task performance-Use of equip/info-Aircraft control-Pilot cause
Environmental issues-Physical environment-Object/animal/substance-Ground equipment-Effect on operation cause
Environmental issues-Conditions/weather/phenomena-Wind-Gusts-Effect on operation cause