N96974 Cessna 182 accident

NTSB GAA19CA246 · 2019-05-05 · Marion, IN · near MZZ

Docket — crew, injuries and powerplant

Summary

The pilot reported that, during landing, the airplane landed hard and bounced. He decided to go around, so he added full power, but the nose pitched up sharply. He added that he attempted to lower the nose, but the airspeed decreased, and the airplane "lost lift on [the] right side." He pushed forward on the control yoke, but the airplane drifted right, the right wing aerodynamically stalled, and the airplane impacted the ground next to a taxiway and spun around. A passenger saw a fire in front of the firewall, and all occupants exited the airplane. The airplane was destroyed by postaccident fire. The pilot reported that there were no preaccident mechanical failures or malfunctions with the airplane that would have precluded normal operation. A Federal Aviation Administration (FAA) inspector reported that the pilot stated he used nose-up trim during the approach. The pilot also stated that, during the go-around, he attempted to use the electric trim to trim nose down. When the airplane nosed up, the pilot attempted to lower the nose but hesitated due to the airplane being near the ground, and he retracted the flaps. The FAA inspector examined the airplane and found that the trim setting was "just short of full nose up trim."

Full narrative

The pilot reported that, during landing, the airplane landed hard and bounced. He decided to go around, so he added full power, but the nose pitched up sharply. He attempted to lower the nose, but the airspeed decreased and he "lost lift on [the] right side". He pushed forward on the control yoke, but the airplane drifted right, the right wing aerodynamically stalled, the airplane impacted the ground next to a taxiway, and spun around. A passenger observed a fire in front of the firewall and all occupants exited the airplane. The airplane was consumed by a postaccident fire and was destroyed.

The Federal Aviation Administration (FAA) inspector reported that the pilot stated he used nose up trim during approach. The pilot added to the FAA inspector that, during the go around, he attempted to use the electric trim to trim nose down. When the airplane nosed up, the pilot attempted to lower the nose, but hesitated due to the close ground proximity and he retracted the flaps. The FAA inspector examined the airplane and observed that the trim setting was "just short of full nose up trim."

The pilot reported that there were no preaccident mechanical failures or malfunctions with the airplane that would have precluded normal operation.

Probable cause

The pilot's improper trim setting and his exceedance of the airplane's critical angle of attack during a go-around, which resulted in an aerodynamic stall. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
Minor
Weather conditions
Visual Meteorological Cond
Light condition
Day
Ceiling (ft)
0
Visibility (sm)
7
Wind direction
0
Temperature (F)
68
Nearest airport
MARION MUNI
Distance from field
0.0
Airport elevation
858

Aircraft

RegistrationMakeModelDamageFAR part
N96974 Cessna 182 DEST 091

Sequence of events

#OccurrencePhase
1 Approach-VFR go-around Miscellaneous/other Cruise
2 Approach-VFR go-around Aerodynamic stall/spin defining Cruise
3 Approach-VFR go-around Attempted remediation/recovery Cruise
4 Approach-VFR go-around Collision with terr/obj (non-CFIT) Cruise

Findings

Finding
Aircraft-Aircraft oper/perf/capability-Performance/control parameters-Angle of attack-Capability exceeded cause
Aircraft-Aircraft systems-Flight control system-Elevator tab control system-Incorrect use/operation cause
Personnel issues-Task performance-Use of equip/info-Aircraft control-Pilot cause