N6314B Cessna 182 accident
NTSB GAA19CA257 · 2019-05-11 · Glades Park, CO
Docket — crew, injuries and powerplant
Summary
The pilot reported that, before departing from a high-altitude (6,830 ft mean sea level), 1,600-ft-long private, dirt airstrip, he set the flaps to 10° and trimmed the airplane. He added that, during takeoff, he advanced the throttle and that the airplane "accelerated well" and that he anticipated that the airplane would become airborne near the first of the runway's "two step downs," which was about 1,000 ft down the runway. He further reported that, although the wind was light and variable, he would be departing with a tailwind. At the first stepdown, he saw that the airspeed was low but he believed that he had gone beyond a "safe shut down point," so he chose to continue the takeoff believing that he would be able to clear the power lines near the departure end of the runway. The airplane became airborne near the departure end of the runway but was unable to maintain a sufficient climb rate to clear the power lines. The airplane struck two sets of power lines and impacted an embankment, and the main landing gear collapsed. The airplane sustained substantial damage to both wings, the fuselage, and the empennage. The pilot reported that there were no preaccident mechanical failures or malfunctions with the airplane that would have precluded normal operation. The calculated density altitude was 8,985 ft.
Full narrative
The pilot reported that, before departing from a high altitude (6,830 ft mean sea level), 1,600 ft private, dirt airstrip, he set the wing flaps to 10° and trimmed the airplane. During takeoff, he advanced the throttle and the airplane "accelerated well". He anticipated becoming airborne near the first of the runway's "two step downs", which was about 1,000 ft down the runway. He further reported that during landing he noted the prevailing wind direction, and although light and variable he would be departing with a tailwind.
At the step down, he observed that the airspeed was low, but felt that he had gone beyond a "safe shut down point", so he chose to continue the takeoff with the belief that he would be able to clear power lines near the departure end of the runway.
The airplane became airborne near the departure end of the runway but was unable to maintain a climb rate enough to clear the power lines. The airplane struck two sets of power lines, impacted an embankment, and the main landing gear collapsed.
The airplane sustained substantial damage to both wings, fuselage, and empennage.
The pilot reported that there were no preaccident mechanical failures or malfunctions with the airplane that would have precluded normal operation.
The automated weather observation station located 13 miles northeast of the accident site reported that, about 7 minutes before the accident, the wind was variable at 3 knots, clear skies, temperature 68°F, dew point 30°F, altimeter setting 29.96" Hg. The calculated density altitude was 8,985 ft. The pilot departed to the southeast.
Probable cause
The pilot's failure to maintain adequate airspeed and climb rate during takeoff in high-density altitude conditions, which resulted in his failure to clear power lines. The National Transportation Safety Board determined the probable cause of this accident.
Circumstances
- Event type
- Accident
- Highest injury
- Minor
- Weather conditions
- Visual Meteorological Cond
- Light condition
- Day
- Sky condition
- NONE
- Ceiling (ft)
- 0
- Visibility (sm)
- 10
- Wind direction
- 0
- Temperature (F)
- 68
- Nearest airport
- Reese Private Strip
- Distance from field
- 0.0
- Airport elevation
- 6980
Aircraft
| Registration | Make | Model | Damage | FAR part |
|---|---|---|---|---|
| N6314B | Cessna | 182 | SUBS | 091 |
Sequence of events
| # | Occurrence | Phase |
|---|---|---|
| 1 | Initial climb Controlled flight into terr/obj (CFIT) defining | Takeoff |
| 2 | Post-impact Landing gear collapse | Approach |