N150SC Cessna TU206 accident

NTSB WPR19LA185 · 2019-07-03 · Waikoloa Village, HI

Docket — crew, injuries and powerplant

Summary

After flying for about 3 hours conducting aerial survey work, the pilot noticed a low oil pressure indication in the cockpit. The pilot prepared for a landing at the destination airport. During the approach he heard a bang and the airplane started to shake. He pitched the airplane to maintain the best glide speed and noticed the engine had lost all oil pressure. The pilot prepared for a forced landing to a road, during which the right wing struck a road sign, and the airplane came to rest in a ditch. Examination of the engine revealed the No. 4 connecting rod crankshaft end and cap separated from the rod and the bolts were sheared. One of the nuts for the connecting rod cap bolts was split and both pieces were recovered. Signatures of high heat on the piston end of all the connecting rods was also noted. The high heat signatures were consistent with a lack of oil lubrication (and subsequent cooling during operation) for the connecting rods at the crankshaft. The lack of lubrication likely caused the failure of the No. 4 connecting rod crankshaft end and cap, which resulted in a total loss of engine power. The reason for the lack of lubrication could not be determined from available information.

Full narrative

On July 3, 2019, at 1035 Hawaii-Aleutian standard time, a Cessna TU206F, N150SC, was substantially damaged when it was involved in an accident near Waikoloa Village, Hawaii. The commercial pilot and passenger were not injured. The airplane was operated as a Title 14 Code of Federal Regulations Part 91 aerial observation flight.

The pilot reported that the flight was destined for Kona, Hawaii, to conduct aerial survey work. After flying for about 3 hours, he noticed a low oil pressure indication in the cockpit. The pilot prepared for a landing at Ellison Onizuka Kona International Airport (PHKO), Kona, Hawaii, during which he heard a “bang” and the airplane started to shake. He pitched the airplane to maintain the best glide speed and noticed the engine had lost all oil pressure. The engine continued to run at an idle setting; however, the pilot had no throttle authority. He prepared for a forced landing to a road, during which the right wing struck a road sign, and the airplane came to rest in a ditch.

Examination of the engine by a Federal Aviation Administration inspector revealed the No. 4 connecting rod crankshaft end and cap separated from the rod and the bolts were sheared. One of the nuts for the connecting rod cap bolts was split and both pieces were recovered. The inspector also noted indications of high heat on the piston end of all the connecting rods with darkening on the crankshaft end of the No. 5 connecting rod.

There were numerous large pieces of the connecting rod cap and pistons that had migrated through the engine case resulting in further damage to several other cylinders and pistons. Cracks were observed on at least two other pistons and damage was noted to the cylinder mounting flanges on at least three cylinders.

Probable cause

The total loss of engine power due to the failure of the No. 4 connecting rod crankshaft end and cap. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
0
Wind speed (kt)
6
Temperature (F)
82
Distance from field
0.0

Aircraft

RegistrationMakeModelDamageFAR part
N150SC Cessna TU206 SUBS 091

Sequence of events

#OccurrencePhase
1 Enroute-cruise Loss of engine power (total) defining Climb
2 Emergency descent Loss of engine power (total) Descent
3 Landing-landing roll Collision with terr/obj (non-CFIT) Cruise

Findings

Finding
Aircraft-Aircraft power plant-(general)-(general)-Failure cause
Aircraft-Fluids/misc hardware-Fluids-Oil-Fluid level factor