N492AC Smyth SIDEWINDER accident

NTSB WPR19LA273 · 2019-09-14 · Tucumcari, NM

Docket — crew, injuries and powerplant

Summary

The pilot reported that during cruise flight, the engine momentarily started to run rough before he heard a loud bang followed by a separation of a portion of the propeller blade. The pilot shut the engine down and performed a forced landing to open desert terrain, during which the airplane impacted vegetation, resulting in substantial damage to the left wing. Postaccident examination of the propeller blade revealed a chordwise fracture across the propeller about 12 inches from the hub. The fracture origin area exhibited a small pit, consistent with progressive crack growth from a flat fracture surface in the area identified as the origin. The pit was likely initiated by corrosion, as it exhibited evidence of chlorine-containing salts. No maintenance logbooks were located for the propeller, and its total time in service and most recent inspection were not determined.

Full narrative

On September 14, 2019, about 1125 mountain daylight time, an experimental, amateur-built Sidewinder airplane, N492AC, was substantially damaged when it was involved in an accident near Tucumcari, New Mexico. The commercial pilot was not injured. The airplane was operated as a Title 14 Code of Federal Regulations Part 91 personal flight.

The pilot reported that, during cruise flight at 11,500 ft mean sea level (msl), the engine momentarily started to run rough. He then heard a loud bang, followed by a portion of propeller blade separating from the fixed-pitch propeller assembly. The pilot shut the engine down by moving the mixture handle to the idle cut-off position and turning off the magneto switch; the engine continued to windmill during the descent and was “still very wobbly.” The pilot performed a forced landing to open desert terrain, during which the airplane impacted vegetation, resulting in substantial damage to the left wing.

Review of photos of the airplane revealed that one of the propeller blades was separated about 12 inches from the hub.

Examination of the propeller fracture surface revealed that the fracture origin area exhibited a small pit. Further examination with a scanning electron microscope revealed fracture features consistent with progressive crack growth from a flat fracture surface in the area that was identified as the origin. The fracture features were consistent with a fatigue fracture originating from the pit. Energy dispersive spectroscopy of the origin area revealed chlorine-containing salts, which were consistent with a corrosion-initiated pit.

No propeller logbooks were located during the investigation. It could not be determined when the propeller was last inspected or overhauled, or its total time in service.

Probable cause

The in-flight separation of a section of a propeller blade due to a fatigue crack, which resulted in a forced landing. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
210
Wind speed (kt)
16
Temperature (F)
84
Distance from field
0.0

Aircraft

RegistrationMakeModelDamageFAR part
N492AC Smyth SIDEWINDER SUBS 091

Sequence of events

#OccurrencePhase
1 Enroute-cruise Part(s) separation from AC defining Climb
2 Landing Off-field or emergency landing Cruise

Findings

Finding
Aircraft-Aircraft propeller/rotor-Propeller system-Propeller blade section-Fatigue/wear/corrosion cause