N441KA Robinson R44 accident

NTSB CEN20CA085 · 2020-02-14 · Marfa, TX

Docket — crew, injuries and powerplant

Summary

The pilot reported that he was flying the helicopter parallel to a 10-ft-tall fence while herding cows into a livestock pen. While maneuvering, the tail rotor struck the fence, and the helicopter spun multiple times. The helicopter ascended about 10 ft, and the pilot retarded the throttle and lowered the collective to the full-down position to minimize the rapid right spin. The helicopter impacted the ground and came to rest upright. The helicopter sustained substantial damage to the tail rotor drive system and tailboom.

Full narrative

The helicopter pilot reported that he was flying parallel to a 10 ft barbed wire fence while herding cows into a livestock pen. While maneuvering, the helicopter's tail rotor struck the fence and the helicopter spun multiple times to the right. The helicopter ascended about 10 ft and the pilot retarded the throttle and lowered the collective to the full down position to minimize the rapid right spin. The helicopter impacted the ground and came to rest upright causing damage to the tail rotor drive system and tail boom.

Probable cause

The pilot's failure to maintain clearance from a fence during low-altitude maneuvering. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
140
Wind speed (kt)
6
Temperature (F)
48
Distance from field
0.0

Aircraft

RegistrationMakeModelDamageFAR part
N441KA Robinson R44 SUBS 091

Sequence of events

#OccurrencePhase
1 Maneuvering-low-alt flying Low altitude operation/event defining Climb
2 Maneuvering-low-alt flying Attempted remediation/recovery Climb

Findings

Finding
Personnel issues-Psychological-Attention/monitoring-Monitoring environment-Pilot cause
Aircraft-Aircraft oper/perf/capability-Performance/control parameters-Altitude-Not attained/maintained cause
Environmental issues-Physical environment-Object/animal/substance-Fence/fence post-Effect on equipment cause