N5478C Cessna 170 accident

NTSB WPR20LA097 · 2020-02-27 · Baker City, OR · near BKE

Docket — crew, injuries and powerplant

Summary

The pilot reported that during a local flight, the engine started to knock and vibrate, and the oil pressure indication was low. He initiated a precautionary landing to an open field, and during the landing rollout, the airplane impacted a small ditch, which resulted in substantial damage to the left wing. A postaccident examination of the engine revealed that the No. 2 connecting rod was separated from the crankshaft. The No. 2 connecting rod journal exhibited thermal distress and mechanical damage. The remaining connecting rod journals and the crankshaft main bearings also exhibited thermal discoloration consistent with oil starvation. When the engine was rotated, no oil flow was observed through the crank journals and lifters. The oil filter screen was covered in dark thick oil and metallic debris and was collapsed. It is likely that the contaminated oil filter screen collapsed under pressure from the oil pump, which prevented the normal flow of oil through the engine; this resulted in the oil starvation of the No. 2 connecting rod bearing and subsequent separation of the connecting rod from the crankshaft.

Full narrative

On February 27, 2020, about 1500 mountain standard time, a Cessna 170, N5478C, was substantially damaged when it was involved in an accident near Baker City, Oregon. The pilot and one passenger were not injured. The airplane was operated as a Title 14 Code of Federal Regulations Part 91 personal flight.

The pilot reported that the purpose of the flight was to warm up the oil before a scheduled annual inspection and oil change. About 15 minutes into the local flight, the engine started to “knock and vibrate badly,” and the oil pressure indication was low. The pilot initiated a precautionary landing to an open field, and during the landing rollout, the airplane impacted a small ditch. The left wing sustained substantial damage.

A postaccident examination of the engine revealed that the No. 2 connecting rod was separated from the crankshaft. The No. 2 connecting rod journal exhibited thermal distress and mechanical damage. The remaining connecting rod journals also exhibited thermal discoloration. The crankshaft main bearings exhibited thermal discoloration and excessive wear. When the engine was rotated, no oil flow was observed through the crank journals and lifters. The oil sump contained metal fragments, and the oil filter screen was covered in dark thick oil and metallic debris and was collapsed. The engine contained about 6 quarts of oil before the examination.

According to the pilot, who was the airplane owner, the engine had 465 hours of operation since the last overhaul.

Probable cause

The failure of the No. 2 connecting rod bearing as a result of oil starvation due to a contaminated oil filter screen.   The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
30
Wind speed (kt)
6
Temperature (F)
57
Nearest airport
Baker City Muni
Distance from field
7.0
Airport elevation
3373

Aircraft

RegistrationMakeModelDamageFAR part
N5478C Cessna 170 SUBS 091

Sequence of events

#OccurrencePhase
1 Enroute Loss of engine power (partial) defining Climb
2 Landing-landing roll Collision during takeoff/land Cruise

Findings

Finding
Aircraft-Aircraft power plant-Engine (reciprocating)-Recip eng cyl section-Failure cause
Environmental issues-Physical environment-Terrain-Rough terrain-Effect on equipment cause
Aircraft-Fluids/misc hardware-Fluids-Oil-Fluid level cause