N7013W M-Squared Sport 1000 accident

NTSB CEN20CA177 · 2020-05-05 · Little Falls, MN · near LXL

Docket — crew, injuries and powerplant

Factual narrative

The uncertificated pilot stated that he replaced the wing and control surface skins of the airplane and planned to perform a test flight. He said that shortly after adding power, the airplane "jumped up" 15 ft off the ground and drifted away from the runway centerline. The pilot applied corrective control inputs to return the airplane back to runway centerline and then applied full engine power to initiate a go-around. About 100 ft agl, the airplane banked hard to the left. The pilot applied right aileron control input but was unable to reduce the bank. The airplane descended and impacted the ground about 200 yards from the end of the runway. The pilot stated that there were no engine-related mechanical anomalies. The flight controls were subject to impact damage; however, the damage was consistent with failures associated with overload due to ground impact and not a failure in flight.

Probable cause

The uncertificated pilot's failure to maintain aircraft control during takeoff, which resulted in an impact with terrain. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
Minor
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
OVC
Ceiling (ft)
10000
Visibility (sm)
10
Wind direction
340
Wind speed (kt)
3
Temperature (F)
50
Nearest airport
Little Falls/Morrison County-L
Distance from field
0.0
Airport elevation
1122

Aircraft

RegistrationMakeModelDamageFAR part
N7013W M-SQUARED Sport 1000 SUBS 091

Sequence of events

#OccurrencePhase
1 Takeoff Loss of control in flight defining Takeoff

Findings

Finding
Personnel issues-Task performance-Use of equip/info-Aircraft control-Pilot cause
Personnel issues-Experience/knowledge-Experience/qualifications-Qualification/certification-Pilot cause