N909C Stinson 108-3 accident

NTSB CEN20LA377 · 2020-09-01 · Coleman, MI

Docket — crew, injuries and powerplant

Summary

The pilot had been flying for about 45 minutes when the airplane experienced a total loss of engine power. The pilot performed a forced landing onto a field. The airplane nosed over and sustained substantial damage to the fuselage and empennage. Postaccident examination of the engine revealed that the single generator drive gear for the ignition system had separated into several pieces. The drive gear shaft installation called for a castellated nut with a cotter pin to retain the drive gear, but the cotter pin had not been installed and allowed the nut to back off, which ceased ignition to the engine. The generator was installed by the pilot, who did not hold a mechanic certificate, during his overhaul of the engine. The pilot stated that he performed the overhaul of the engine and installation of the generator under the supervision of a mechanic with an airframe and powerplant ratings. No other mechanical anomalies with the engine were noted.

Full narrative

On September 1, 2020, at 1100 eastern daylight time, a Stinson 108-3, N909C, was substantially damaged when it was involved in an accident near Coleman, Michigan. The pilot was uninjured. The airplane was operated as a Title 14 Code of Federal Regulations Part 91 personal flight.

The pilot stated that the airplane had been flying for about 45 minutes before it experienced a total loss of engine power. The pilot then performed a forced landing to a soybean field, where it rolled for about 180 ft and nosed over resulting in substantial damage to the fuselage and empennage.

Postaccident examination of the engine, by a Federal Aviation Administration representative, revealed the single generator drive gear for the ignition system had separated into several pieces. The drive gear shaft installation called for a castellated nut with a cotter pin to retain the drive gear, but the cotter pin had not been installed and allowed the nut to back off. The generator was installed by the pilot, who did not hold a mechanic certificate, during his overhaul of the engine. The pilot stated that he performed the overhaul of the engine and installation of the generator under the supervision of a mechanic with an airframe and powerplant ratings. No other mechanical anomalies with the engine were noted.

Probable cause

The pilot’s improper installation of the generator drive gear, which resulted in a total loss of engine power. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Wind direction
0
Distance from field
0.0

Aircraft

RegistrationMakeModelDamageFAR part
N909C Stinson 108-3 SUBS 091

Sequence of events

#OccurrencePhase
1 Enroute-cruise Powerplant sys/comp malf/fail defining Climb
2 Enroute-cruise Loss of engine power (total) Climb
4 Landing Collision with terr/obj (non-CFIT) Cruise
5 Prior to flight Aircraft maintenance event Standing
6 Prior to flight Aircraft inspection event Standing

Findings

Finding
Aircraft-Aircraft power plant-Ignition system-Magneto/distributor-Failure cause
Personnel issues-Task performance-Inspection-Post maintenance inspection-Maintenance personnel factor
Personnel issues-Task performance-Maintenance-Installation-Pilot cause