N5179G accident

NTSB ERA21LA044 · 2020-11-14 · Ellenville, NY · near N89

Docket — crew, injuries and powerplant

Factual narrative

The pilot of the tailwheel-equipped airplane was performing touch-and-go landings. During the third landing, the pilot noticed that right wheel began to “drag.” During the next landing, the airplane veered to the right side of the runway. The tail of the airplane then lifted and the airplane nosed over. The fuselage, wings, and vertical stabilizer were substantially damaged. After exiting the airplane, the pilot attempted to rotate the right wheel assembly, and it would not rotate. After about an hour the wheel assembly freed up and was able to rotate. A postaccident examination of the brake system revealed that the brake master cylinder lock seal spring had broken into three pieces. Given this information, it is likely that the broken lock seal spring washer prevented the master cylinder from releasing pressure from the caliper. This malfunction resulted in the right brake caliper staying engaged after the pilot released the brakes.

Probable cause

The failure of the right brake master cylinder lock seal spring washer. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
290
Wind speed (kt)
12
Temperature (F)
48
Nearest airport
Joseph Y Resnick Airport
Distance from field
0.0
Airport elevation
292

Aircraft

RegistrationMakeModelDamageFAR part
N5179G — — SUBS 091

Sequence of events

#OccurrencePhase
1 Landing Nose over/nose down Cruise
4 Landing-landing roll Sys/Comp malf/fail (non-power) defining Cruise

Findings

Finding
Aircraft-Aircraft systems-Landing gear system-Brake-Malfunction cause
Aircraft-Aircraft systems-Landing gear system-Master cylinder/brake valve-Failure cause