N5098E accident

NTSB WPR21LA069 · 2020-12-13 · San Diego, CA · near MYF

Docket — crew, injuries and powerplant

Summary

According to the flight instructor, the purpose of the flight was for the student pilot to practice touch-and-go landings. During the second takeoff, as the airplane was about 100-150 ft above ground level, he detected a loss of engine power and assumed control of the airplane. He landed the airplane on the remaining runway but overran the departure end of the runway and struck the airport perimeter fence. Both wings sustained substantial damage. Examination of the engine revealed that the No. 3 exhaust rocker arm stud was fractured. Metallurgical examination of the fracture surfaces on the rocker arm stud revealed that it had fractured due to fatigue. The fatigue fracture of the No. 3 exhaust valve rocker arm stud likely led to the partial loss of engine power.

Full narrative

On December 13, 2020, about 1250 Pacific standard time, a Cessna 172, N5098E, was substantially damaged when it was involved in an accident near San Diego, California. The flight instructor and student were not injured. The airplane was operated as a Title 14 Code of Federal Regulations Part 91 instructional flight.

The flight instructor reported that the purpose of the flight was for the student pilot to practice touch-and-go landings. During the second takeoff on runway 28R, as the airplane was about 100-150 ft above ground level, the flight instructor detected a loss of engine power and assumed control of the airplane. He landed the airplane on the remaining runway; however, the airplane overran the departure end of the runway and struck and airport perimeter fence.

Postaccident examination of the airplane by a Federal Aviation Administration inspector revealed that both wings and the fuselage sustained substantial damage. Subsequent examination of the airplane’s engine revealed that the No. 3 cylinder’s intake shroud tube was bent. Removal of the No. 3 cylinder’s rocker box cover identified the exhaust valve rocker arm stud had separated. The exhaust valve rocker arm seat, rocker arm, washer, and a section of the stud with self-locking nut were loose within the rocker box cover. Fretting was observed at the mating surface for the rocker arm seat, the rocker arm seat, the shroud tube and the push rod assembly.

The rocker arm stud was sent to National Transportation Safety Board Materials Laboratory, Washington, DC, for examination. The examination of the fracture surface revealed characteristics consistent with a fatigue fracture. Review of maintenance records did not reveal if the stud was ever replaced or inspected during the major overhaul.

Probable cause

A partial loss of engine power due to the fatigue fracture of the No. 3 exhaust valve rocker arm stud. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
250
Wind speed (kt)
9
Temperature (F)
66
Nearest airport
MONTGOMERY-GIBBS EXECUTIVE
Distance from field
0.0
Airport elevation
427

Aircraft

RegistrationMakeModelDamageFAR part
N5098E — — SUBS 091

Sequence of events

#OccurrencePhase
1 Takeoff Loss of engine power (partial) defining Takeoff
2 Landing Runway excursion Cruise
3 Landing Collision with terr/obj (non-CFIT) Cruise

Findings

Finding
Aircraft-Aircraft power plant-Engine (reciprocating)-Recip eng cyl section-Fatigue/wear/corrosion cause
Aircraft-Aircraft power plant-Engine (reciprocating)-Recip eng cyl section-Failure cause