N8051B accident

NTSB CEN21LA218 · 2021-05-13 · Tulsa, OK · near TUL

Docket — crew, injuries and powerplant

Factual narrative

The pilot reported that during a post-maintenance check flight, when he went to retract the landing gear after takeoff, he noticed that the amber light that indicated the gear was fully retracted, did not illuminate. The pilot verified the main landing gear indicator lights functioned and decided to validate in flight that the landing gear would extend. When he extended the landing gear, the green light that indicated the landing gear was down and locked did not illuminate, and the pilot was not able to visually confirm the extension of the main landing gear. After troubleshooting the system and several unsuccessful attempts to extend the main landing gear, the pilot performed a gear-up landing to the dry asphalt runway, with only the nose wheel extended. The airplane slid 500 ft before coming to a stop. The airplane sustained substantial damage to the right horizonal stabilizer and elevator. A postaccident examination of the airplane revealed that a b-nut on the main landing gear actuator gear down hydraulic line was only hand tightened, with visible stripped thread present. The mechanic who performed the annual inspection on the airplane, which included work on the main landing gear system, reported that he forgot to fully tighten the b-nut during the recent maintenance work, which resulted in a loss of main landing gear system hydraulic pressure in flight, and the pilot’s inability to fully extend the main landing gear. A successful main landing gear swing was performed during the maintenance work, but it was not performed after all the maintenance work was completed. Had the main landing gear swing been conducted after the maintenance work was completed, it is likely the loss of the main landing gear system hydraulic pressure would have been identified before the flight.

Probable cause

The pilot’s inability to extend the main landing gear due to incomplete maintenance, which resulted in a partial wheels-up landing and the mechanic’s failure to follow proper maintenance procedures that led to the loss of main landing gear system hydraulic pressure and the subsequent failure of the main landing gear to fully extend. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Night
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
320
Wind speed (kt)
4
Temperature (F)
50
Nearest airport
TULSA INTL
Distance from field
0.0
Airport elevation
677

Aircraft

RegistrationMakeModelDamageFAR part
N8051B — — SUBS 091

Sequence of events

#OccurrencePhase
1 Landing Sys/Comp malf/fail (non-power) defining Cruise
2 Prior to flight Aircraft maintenance event Standing
3 Landing Landing gear not configured Cruise
4 Landing Off-field or emergency landing Cruise
5 Landing Attempted remediation/recovery Cruise
6 Landing Abnormal runway contact Cruise

Findings

Finding
Personnel issues-Psychological-Attention/monitoring-Attention-Maintenance personnel cause
Personnel issues-Task performance-Maintenance-Scheduled/routine maintenance-Maintenance personnel cause
Aircraft-Aircraft systems-Landing gear system-Main landing gear-Failure cause
Aircraft-Aircraft systems-Landing gear system-Main landing gear-Incorrect service/maintenance cause