N974CQ Hph Ltd GLASFLUGEL accident

NTSB WPR21LA235 · 2021-06-20 · Winthrop, WA

Docket — crew, injuries and powerplant

Factual narrative

The glider pilot reported that after an uneventful tow to 4,000 ft msl (about 2,300 ft agl), he proceeded to fly north with the intention of reaching a mountain peak about 40 miles away. Soaring conditions were good, and the glider had climbed to about 10,500 ft msl by the time he reached a peak at the halfway point. On the second leg, the glider started to encounter sink, and the pilot continued to fly along mountain ridges to regain altitude. The pilot managed to climb the glider back to 8,000 ft, but again began to encounter sink and decided to work along mountain ridges back to the south with the intention of landing at an intermediary airport. He was not able to maintain altitude, and ultimately decided to perform an off-airport landing into a valley clearing. During the landing roll the right wing was substantially damaged when it struck a tree. The pilot reported that there were no mechanical failures or malfunctions with the glider that would have precluded normal operation.

Probable cause

The glider’s encounter with atmospheric conditions where the lift was not sufficient to maintain flight. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
Minor
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
200
Wind speed (kt)
7
Temperature (F)
111
Distance from field
0.0

Aircraft

RegistrationMakeModelDamageFAR part
N974CQ HPH LTD GLASFLUGEL SUBS 091

Sequence of events

#OccurrencePhase
1 Enroute Loss of lift defining Climb
2 Landing Off-field or emergency landing Cruise
3 Landing Collision with terr/obj (non-CFIT) Cruise

Findings

Finding
Environmental issues-Conditions/weather/phenomena-Temp/humidity/pressure-Thermal lifting-Effect on operation cause
Aircraft-Aircraft oper/perf/capability-Performance/control parameters-Altitude-Attain/maintain not possible cause