N3059X accident
NTSB ERA21LA297 · 2021-07-23 · Arden, NC · near AVL
Docket — crew, injuries and powerplant
Summary
The student pilot was climbing through 5,100 feet mean sea level when the engine “went to idle.” He attempted to adjust the throttle setting; however, the tachometer continued to indicate 740 rpm. The pilot established best glide speed, declared an emergency, and performed a forced landing into a coal ash pit, during which the airplane nosed over, resulting in substantial damage. Examination of the engine revealed that the throttle control cable had separated from the throttle control lever and there was no spring installed. The securing hardware (bolt/washer/cotter pin) was not found. It is likely that the absence of the cotter pin was not noted during the annual inspection 15 hours before the accident, which allowed the bolt holding the throttle cable to the throttle control lever to loosen and depart during flight, resulting in an engine power reduction to idle.
Full narrative
On July 23, 2021, about 1830 eastern daylight time, a Cessna 150F, N3059X, was substantially damaged when it was involved in an accident near Arden, North Carolina. The student pilot was not injured. The airplane was operated as a Title 14 Code of Federal Regulations Part 91 personal flight. The pilot departed Asheville Regional Airport (AVL), Asheville, North Carolina, and was climbing through 5,100 feet mean sea level when the engine “went to idle.” The pilot attempted to adjust the throttle setting; however, the tachometer continued to indicate 740 rpm. The pilot established best glide speed, declared an emergency, and turned back toward AVL. When he determined that he could not reach the airport, he performed a forced landing into a coal ash pit; during the landing roll, the airplane nosed over.
Examination of the accident site by a Federal Aviation Administration inspector revealed substantial damage to the airplane’s left wing, rudder, and fuselage. The engine throttle cable was separated from the carburetor throttle control lever. The securing hardware (bolt/washer/cotter pin) was not found and there was no evidence of impact damage to the lever or carburetor.
Examination of the carburetor after the airplane was recovered revealed that the throttle control lever was in the full forward (or wide-open) position, which matched the position of the cockpit control. The throttle control cable was separated from the intact throttle control lever. Further examination of the throttle control lever revealed that there was no spring installed. Review of maintenance records and the tachometer revealed that the accident occurred 15 hours after the airplane’s most recent annual inspection.
Probable cause
The inadequate inspection of the throttle control cable assembly, which resulted in a partial loss of engine power during cruise flight. The National Transportation Safety Board determined the probable cause of this accident.
Circumstances
- Event type
- Accident
- Highest injury
- None
- Weather conditions
- Visual Meteorological Cond
- Light condition
- Day
- Sky condition
- BKN
- Ceiling (ft)
- 3700
- Visibility (sm)
- 7
- Wind direction
- 210
- Wind speed (kt)
- 9
- Temperature (F)
- 82
- Nearest airport
- ASHEVILLE RGNL
- Distance from field
- 2.0
- Airport elevation
- 2164
Aircraft
| Registration | Make | Model | Damage | FAR part |
|---|---|---|---|---|
| N3059X | — | — | SUBS | 091 |
Sequence of events
| # | Occurrence | Phase |
|---|---|---|
| 1 | Enroute-climb to cruise Loss of engine power (partial) defining | Climb |
| 2 | Enroute-climb to cruise Off-field or emergency landing | Climb |
| 3 | Prior to flight Aircraft maintenance event | Standing |