N666JS CHR International Safari 400 accident

NTSB CEN22LA068 · 2021-12-09 · McKinney, TX · near TKI

Docket — crew, injuries and powerplant

Factual narrative

The pilot reported that he drove from his home to the airport not expecting to fly the helicopter due to high winds, however, after arrival at the hangar the winds were lighter than the forecast winds, so he conducted a preflight for a local flight. As the pilot raised the collective for takeoff and the helicopter climbed into an initial hover, the helicopter rolled to the left. The pilot tried to counter the roll but was unable because the cyclic control lock was still in place. The helicopter continued to roll left and impacted the ramp and a post impact fire ensued. The pilot successfully egressed the helicopter but suffered serious burn injuries. The helicopter sustained substantial damage to the main rotor system and the cabin. The pilot reported that there were no preaccident mechanical malfunctions or failures that would have precluded normal operation.

Probable cause

The pilot did not remove the cyclic control lock during preflight, which resulted in a loss of control during the initial hover. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
Serious
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
200
Wind speed (kt)
7
Temperature (F)
75
Nearest airport
MCKINNEY NTL
Distance from field
1.0
Airport elevation
588

Aircraft

RegistrationMakeModelDamageFAR part
N666JS CHR International Safari 400 SUBS 091

Sequence of events

#OccurrencePhase
2 Prior to flight Preflight or dispatch event Standing
3 Takeoff Loss of control in flight defining Takeoff

Findings

Finding
Personnel issues-Task performance-Inspection-Preflight inspection-Pilot cause
Aircraft-Aircraft handling/service-Maintenance/inspections-(general)-Inadequate inspection factor
Aircraft-Aircraft oper/perf/capability-Performance/control parameters-Lateral/bank control-Attain/maintain not possible cause