N7733Q accident

NTSB ERA22LA198 · 2022-04-13 · Selma, AL · near SEM

Docket — crew, injuries and powerplant

Summary

The pilot reported that airplane had been painted and the rudder reinstalled before the accident flight. He stated that immediately after takeoff he noticed that he needed to use significant left rudder to maintain directional control. He executed a precautionary landing on the airport property, landing hard in the grass at a 45° angle to the runway. The fuselage sustained substantial damage and the nose landing gear fractured during the landing. Postaccident examination of the airplane revealed that the rudder trim system was significantly out of rig. The pilot was unable to provide any maintenance records relating to the rudder removal and reinstallation. It is likely that the rudder and/or its trim system was installed incorrectly following the airplane’s repainting, which resulted in the pilot’s difficulty maintaining directional control and inability to make a normal landing on the runway. Although the pilot indicated that he performed the preflight checklist before takeoff, he stated that he may not have checked the control trims that are part of that checklist. It is likely that, had the pilot completed a preflight control check before the flight, he would have identified the improperly rigged rudder trim system.

Full narrative

On April 13, 2022, about 1415 central daylight time, a Cessna 310Q, N7733Q, was substantially damaged when it was involved in an accident near Selma, Alabama. The pilot and pilot-rated passenger were not injured. The airplane was operated as a Title 14 Code of Federal Regulations Part 91 personal flight.

The pilot reported that, immediately after takeoff, he needed to use significant left rudder to maintain directional control. After observing the engine monitors and noting that both engines were producing power, he held full left aileron and rudder input to maintain level flight and instructed the pilot-rated passenger to adjust the throttles to turn the airplane back to the airport for a precautionary landing. They were able to maneuver the airplane to land on the airport property, landing hard in the grass at a 45° angle to the runway. The nose landing gear fractured during landing.

Examination of the airplane by a Federal Aviation Administration inspector revealed substantial damage to the fuselage. The inspector also reported that the accident flight was the first flight after the airplane had been painted, and that the flight controls had been removed for the painting. Numerous placards were missing or obscured by paint, and painter’s tape was still attached in some areas. The rudder trim system was found to be significantly out of rig, and the inspectors were unable to move the rudder trim tab to the neutral position.

The pilot was unable to provide any maintenance records relating to the rudder removal and reinstallation or a subsequent weight and balance check/adjustment. Although the pilot indicated that he performed the preflight checklist before takeoff, he stated that he may not have checked the control trims that are part of that checklist.

Probable cause

The failure of maintenance personnel to properly rig the rudder trim system after reinstallation and pilot’s inadequate preflight inspection after recent maintenance, which resulted in an inability to adequately maintain directional control during the flight. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Ceiling (ft)
0
Visibility (sm)
8
Wind direction
160
Wind speed (kt)
9
Temperature (F)
79
Nearest airport
Craig Field Airport
Distance from field
0.0
Airport elevation
166

Aircraft

RegistrationMakeModelDamageFAR part
N7733Q — — SUBS 091

Sequence of events

#OccurrencePhase
2 Landing-flare/touchdown Abnormal runway contact Cruise
3 Landing-landing roll Runway excursion Cruise
4 Prior to flight Aircraft maintenance event Standing
6 Prior to flight Aircraft inspection event Standing
7 Initial climb Loss of control in flight defining Takeoff

Findings

Finding
Aircraft-Aircraft systems-Flight control system-Rudder control system-Incorrect service/maintenance cause
Aircraft-Aircraft systems-Flight control system-Rudder control system-Not inspected cause
Aircraft-Aircraft oper/perf/capability-Performance/control parameters-Directional control-Attain/maintain not possible factor
Personnel issues-Task performance-Inspection-Preflight inspection-Pilot cause
Personnel issues-Task performance-Maintenance-Installation-Maintenance personnel cause