N69PW accident

NTSB CEN24LA178 · 2024-05-08 · Midland, TX · near 7T7

Docket — crew, injuries and powerplant

Factual narrative

The pilot reported he was landing the airplane when a strong gust of wind pushed the airplane to the right about halfway down the runway. The pilot reported that after he initiated a go-around, the airplane became uncontrollable which resulted in an aerodynamic stall and impact with the ground. The impact resulted in substantial damage to the left wing and fuselage. Initially the pilot reported that there were no mechanical malfunctions related to the airplane so the airplane was released to the owner. Later, the pilot reported that he did not hear the stall horn and suspected it was inoperable. He also stated that the flap switch physically stuck in the up position which retracted the flaps fully and contributed to the stall. The pilot was asked to describe the normal operation of the flap switch. He stated that holding the switch up raises the flaps, holding the switch down lowers the flaps, and letting go of the switch shuts off the flap motor. When follow up was conducted on the reported mechanical issues, the airplane was found stripped of parts, thus examination of the stall horn was not possible. The flap switch was removed and examined. The flap switch specifications and the Pilot Operating Handbook both stated that the switch would remain in the up position until the switch was physically moved to the center (off) position, thus if the pilot let go of the switch while raising the flaps, the switch would stay in the up position and continue to raise the flaps to zero. During a go around, the flaps should have initially been retracted to 20 degrees which would require the pilot to move the flap switch back to the neutral position after the flaps reached 20 degrees. After the airplane was established in a climb, the remaining flaps would be retracted by returning the flap switch to the up position. The switch was found to operate normally with no defects found. Based on the pilot’s description of the flap switch operation it is likely he did not know how the switch functioned.

Probable cause

The pilot’s failure to maintain airplane control during a go-around in a gusting crosswind, which resulted in an aerodynamic stall and collision with terrain. Contributing to the accident was the pilot’s lack of system knowledge regarding the operation of the flaps. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
280
Wind speed (kt)
14
Temperature (F)
88
Nearest airport
Skywest Airport
Distance from field
0.0
Airport elevation
2805

Aircraft

RegistrationMakeModelDamageFAR part
N69PW — — SUBS 091

Sequence of events

#OccurrencePhase
1 Approach-VFR go-around Loss of control in flight defining Cruise
2 Approach-VFR go-around Aerodynamic stall/spin Cruise
3 Uncontrolled descent Collision with terr/obj (non-CFIT) Descent

Findings

Finding
Aircraft-Aircraft systems-Flight control system-TE flap control system-Incorrect use/operation cause
Personnel issues-Experience/knowledge-Knowledge-Knowledge of equipment-Pilot cause
Environmental issues-Conditions/weather/phenomena-Wind-Gusts-Effect on operation factor
Aircraft-Aircraft oper/perf/capability-Performance/control parameters-Airspeed-Not attained/maintained cause
Personnel issues-Task performance-Use of equip/info-Aircraft control-Pilot cause