N20747 accident

NTSB CEN24LA350 · 2024-09-11 · Englewood, CO

Docket — crew, injuries and powerplant

Summary

While performing touch-and-go landings, the flight instructor and student pilot noticed a partial loss of engine power on climbout, about 200 ft above ground level (agl). The flight instructor reported the tachometer read 2,100 and then 1,600 rpm. During a forced landing to a golf course, the airplane’s nose landing gear collapsed and the airplane came to rest inverted. A postimpact test of the engine’s fuel injection servo found fuel flow below the minimum service limit at most test points. When the servo was disassembled, a thick blue liquid consistent with a fuel-oil mixture was found in the venturi chambers. Oil residue was noted in the hex plug and air diaphragm, the spring and stem assembly, and the air passage to the air diaphragm. No other anomalies were detected with the engine. A service bulletin from the fuel injection servo manufacturer states that this type of contamination could cause an engine to exhibit “gradually deteriorating idle, difficulty starting and/or cold engine acceleration performance.” The flight school was aware of the service bulletin and was inspecting airplanes that had the engine symptoms listed in the service bulletin. It is likely that contamination of the fuel injection servo resulted in a partial loss of engine power and subsequent forced landing.

Full narrative

On September 11, 2024, about 0940 mountain daylight time, a Cessna 172S airplane, N20747, was substantially damaged when it was involved in an accident near Englewood, Colorado. The flight instructor was not injured and the student pilot sustained minor injuries. The airplane was operated as a Title 14 Code of Federal Regulations Part 91 instructional flight.

The pilots were performing touch-and-go landings on runway 17R at Centennial Airport (APA), Englewood, Colorado. On climbout for the traffic pattern, when the airplane was about 200 ft agl, the pilots noticed a partial loss of engine power. The instructor reported the tachometer read 2,100 and then 1,600 rpm. He performed a forced landing to a golf course. During the landing roll, the airplane’s nose landing gear collapsed and the airplane came to rest inverted.

A review of maintenance logbook entries found that on September 5, 2024, about one week before the accident flight, another pilot reported that the airplane “was only getting 2,000 rpm at max power and was backfiring constantly in the run-up.” However, maintenance personnel found that the engine operated satisfactorily during a subsequent ground run-up. The airplane was then flown daily without any reported engine problems until the accident takeoff.

A postimpact examination of the engine revealed no evidence of any preimpact mechanical malfunctions or failures that would have precluded normal operation. However, during a bench test of the engine’s fuel injection servo (AVStar part number LFR-NNSS5), fuel flow was below the minimum service limit at most test points. When the servo was disassembled, a thick blue liquid consistent with a fuel-oil mixture was found in the venturi chambers. Oil residue was noted in the hex plug and air diaphragm, the spring and stem assembly, and the air passage to the air diaphragm. The AVStar LFR-NNSS5 is a variant of the RSA-5AD1 fuel injection servo and was mounted in an updraft configuration on the accident airplane. AVStar service bulletin AFS-SB10, Fuel Servos Installed in an Updraft Configuration, is applicable to RSA-5AD1 servos and states: There have been occasional reports of servo equipped engines that exhibit one or more of the following characteristics - gradually deteriorating idle, difficulty starting and/or cold engine acceleration performance. These engines may have the servo mounted in an updraft, or nearly updraft configuration. Close inspection of the servo may reveal oily contaminant in the bore of the servo that is green/blue in color. It is also possible for this contaminant to migrate into the air section of the regulator.

The Precision Airmotive service information letter SIL RS-40, Service Information For RSA-5 Series Fuel Injection Servos Installed in Updraft Configuration, similarly notes reports of reduced engine performance and recommends inspection of fuel injection servos for contamination if these problems are experienced. The flight school’s maintenance personnel stated they were aware of AVStar AFS-SB10 and Precision Airmotive SIL ARS-40 and routinely inspected their airplanes that had any symptoms listed in AFS-SB10. In addition, they reported that they caution their pilots against over-priming the engine during engine starts.

Probable cause

A partial loss of engine power due to fuel-oil contamination of the fuel injection servo. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
Minor
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
BKN
Ceiling (ft)
22000
Visibility (sm)
10
Wind direction
300
Wind speed (kt)
7
Temperature (F)
72
Distance from field
0.0

Aircraft

RegistrationMakeModelDamageFAR part
N20747 — — SUBS 091

Sequence of events

#OccurrencePhase
1 Initial climb Loss of engine power (partial) Takeoff
2 Initial climb Off-field or emergency landing Takeoff
3 Landing Collision with terr/obj (non-CFIT) Cruise
4 Initial climb Powerplant sys/comp malf/fail defining Takeoff

Findings

Finding
Aircraft-Aircraft power plant-Engine fuel and control-Fuel control/carburetor-Damaged/degraded cause