N916PH Vans Aircraft Inc RV-12 accident

NTSB WPR24LA322 · 2024-09-27 · Paris, ID · near 1U7

Docket — crew, injuries and powerplant

Factual narrative

The pilot was practicing a soft field takeoff. As the airplane accelerated the nose lifted more than anticipated and at a lower airspeed. The airplane drifted left off the runway surface and the pilot decreased power and attempted to correct the heading change with rudder, but the airspeed was too low for the rudder to be effective. The airplane struck a precision approach path indicator (PAPI) assembly and the pilot brought the airplane to a stop. The pilot determined he had incorrectly set the flaps to the second notch (full down) instead of the first notch specified in the pilot’s operating handbook, which he said contributed to the conditions leading to the loss of control. He further stated there were no mechanical anomalies with the airplane that contributed to the accident. The airplane sustained substantial damage to the right wing.

Probable cause

The pilot’s failure to properly configure the flaps, which resulted in a loss of directional control during takeoff. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
0
Temperature (F)
79
Nearest airport
BEAR LAKE COUNTY
Distance from field
0.0
Airport elevation
5932

Aircraft

RegistrationMakeModelDamageFAR part
N916PH VANS AIRCRAFT INC RV-12 SUBS 091

Sequence of events

#OccurrencePhase
1 Takeoff Loss of control on ground defining Takeoff

Findings

Finding
Personnel issues-Task performance-Use of equip/info-Use of checklist-Pilot factor
Personnel issues-Task performance-Use of equip/info-Aircraft control-Pilot cause
Aircraft-Aircraft oper/perf/capability-Performance/control parameters-Directional control-Not attained/maintained cause
Aircraft-Aircraft systems-Flight control system-TE flap control system-Incorrect use/operation cause