N75775 accident

NTSB CEN25LA168 · 2025-05-04 · Longmont, CO · near LMO

Docket — crew, injuries and powerplant

Summary

The student pilot stated that he was on final approach when he noticed that the engine was not responding to his throttle control changes. The engine speed was about 2,000 rpm when he attempted a go-around; however, the engine power did not increase as he applied full throttle, and the airplane would not climb due to the low power setting. The student noted that the engine subsequently lost power completely and he executed a forced landing to a field. During the landing, the airplane struck a fence and nosed over. The airframe sustained substantial damage to the right wing, vertical stabilizer, and rudder. A post-accident examination determined that the throttle cable was disconnected from the carburetor. Both the throttle cable and the carburetor control arm moved freely and there was no evidence of damage to either component. The connecting hardware – bolt and nut – were not observed at the time of the examination. Airplane maintenance records revealed that a 100-hour inspection was completed three weeks before the accident, and the engine carburetor was replaced at that time. The airplane had accumulated about 9.9 hours flight time since that maintenance work. The mechanic stated that an apprentice had replaced the carburetor and the mechanic had gotten busy with other tasks and did not fully inspect the apprentice’s work.

Full narrative

On May 4, 2025, about 1200 mountain daylight time, a Cessna 172N airplane, N75775, was substantially damaged when it was involved in an accident near Longmont, Colorado. The student pilot was not injured. The airplane was operated as a Title 14 Code of Federal Regulations Part 91 instructional flight.  The student pilot stated that he was on final approach when he noticed that the engine was not responding to his throttle control changes. The engine speed was about 2,000 rpm when he attempted a go-around. However, the engine power did not increase as he applied full throttle, and the airplane would not climb due to the low power setting. He noted that the engine subsequently lost power completely and he executed a forced landing to a field. During the landing, the airplane struck a fence and nosed over. The airframe sustained substantial damage to the right wing, vertical stabilizer, and rudder.

A post-accident examination conducted by a Federal Aviation Administration inspector determined that the throttle cable was disconnected from the carburetor. Both the throttle cable and the carburetor control arm moved freely and there was no evidence of damage to either component. The connecting hardware – bolt and nut – were not observed at the time of the examination.

Airplane maintenance records revealed that a 100-hour inspection was completed three weeks before the accident, and the engine carburetor was replaced at that time. The airplane had accumulated about 9.9 hours flight time since that maintenance. The mechanic noted that an apprentice had replaced the carburetor. He had gotten busy with other tasks and did not fully inspect the apprentice’s work.

Probable cause

The disconnected throttle control that resulted in a loss of engine power due to improper maintenance. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
340
Wind speed (kt)
5
Temperature (F)
70
Nearest airport
VANCE BRAND
Distance from field
0.5
Airport elevation
5055

Aircraft

RegistrationMakeModelDamageFAR part
N75775 — — SUBS 091

Sequence of events

#OccurrencePhase
1 Approach-VFR go-around Loss of engine power (partial) defining Cruise
2 Emergency descent Off-field or emergency landing Descent
3 Landing-landing roll Nose over/nose down Cruise

Findings

Finding
Aircraft-Aircraft power plant-Engine controls-Power lever-Inoperative cause
Aircraft-Aircraft power plant-Engine controls-Power lever-Incorrect service/maintenance cause
Personnel issues-Task performance-Maintenance-Installation-Maintenance personnel cause