N6174A accident
NTSB CEN25LA218 · 2025-06-19 · Huron, SD
Docket — crew, injuries and powerplant
Factual narrative
The pilot reported that she was practicing a low-level aerial application flight of applying water to a field. During the third pass, she pushed the spray lever forward and inadvertently pushed the dump lever with her knuckles, which opened the gate to the hopper. She closed the gate and continued spraying, then climbed out of the field. The airplane entered an aerodynamic stall during the climb and the pilot applied full power; however, the airplane continued to stall at a low altitude and landed hard in a field. The airplane came to rest upright and sustained substantial damage to the fuselage and both wings. The pilot reported there were no preimpact mechanical malfunctions or failures with the airframe or the engine that would have precluded normal operation. The pilot reported the airplane was equipped with a stall warning system. She further reported that she obtained her aerial application airplane operation logbook endorsement 36 days before the accident date.
Probable cause
The pilot’s exceedance of the airplane’s critical angle of attack during a low-level aerial application, which resulted in an aerodynamic stall and loss of airplane control at too low of an altitude to recover. The National Transportation Safety Board determined the probable cause of this accident.
Circumstances
- Event type
- Accident
- Highest injury
- None
- Weather conditions
- Visual Meteorological Cond
- Light condition
- Day
- Sky condition
- NONE
- Ceiling (ft)
- 0
- Visibility (sm)
- 10
- Wind direction
- 200
- Wind speed (kt)
- 9
- Temperature (F)
- 81
- Distance from field
- 0.0
Aircraft
| Registration | Make | Model | Damage | FAR part |
|---|---|---|---|---|
| N6174A | — | — | SUBS | 137 |
Sequence of events
| # | Occurrence | Phase |
|---|---|---|
| 4 | Maneuvering-low-alt flying Aerodynamic stall/spin | Climb |
| 5 | Maneuvering-low-alt flying Loss of control in flight defining | Climb |