N670P Cirrus Design Corp SR22 accident

NTSB CEN25LA223 · 2025-06-25 · Unionville, MO · near K43

Docket — crew, injuries and powerplant

Factual narrative

The student pilot stated that while on the downwind leg of the traffic pattern he applied 50% flap deployment, then when established on final approach he applied 100% flap deployment. He crossed the runway threshold about 78 knots and began the landing flare. He stated he was expecting the airplane to float but the airplane dropped 3 to 4 ft and bounced. He said after the bounce the airplane ballooned up about 8 to 10 ft and he elected to execute a go-around. He retracted the flaps to 50% and applied full power. The airplane drifted to the left and he attempted correct with right rudder until the airplane struck the ground. In his written report, the pilot indicated that there were no mechanical malfunctions or failures of the airplane that led to the accident.

Probable cause

The pilot’s failure to maintain airplane control during a go-around. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
Minor
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
BKN
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
220
Wind speed (kt)
12
Temperature (F)
88
Nearest airport
UNIONVILLE MUNI
Distance from field
0.0
Airport elevation
1045

Aircraft

RegistrationMakeModelDamageFAR part
N670P CIRRUS DESIGN CORP SR22 DEST 091

Sequence of events

#OccurrencePhase
3 Approach-VFR go-around Loss of control in flight defining Cruise

Findings

Finding
Personnel issues-Task performance-Use of equip/info-Aircraft control-Pilot cause
Aircraft-Aircraft oper/perf/capability-Performance/control parameters-(general)-Not attained/maintained cause