N5204C accident

NTSB WPR25LA221 · 2025-07-24 · Helena, MT · near HLN

Docket — crew, injuries and powerplant

Factual narrative

The pilot was returning to his home airport and approached the airport from the north. He was initially cleared to land runway 27 but requested to land runway 17 because he was conveniently aligned with it. When about five miles from the airport he slowed the airplane, lowered the landing gear, and “pulled the throttle all the way back.” He stated that he did not recall “raising the propeller speed.” He further stated that he was too high, and extended the flaps to full down, which was something he normally did not do. During the landing flare, he waited for the airplane to settle onto the runway. He realized that the airplane had not touched down as it passed the midpoint of the 2,989 ft long runway and initiated a go-around. During the go-around, the pilot initially thought he had pushed the throttle control full forward, but when “nothing happened,” he looked down and realized he had pushed the mixture control forward. He added throttle and felt the airplane pick up speed. The pilot recalled that he pulled the yoke back to clear the airport perimeter fence and felt the airplane climb. The pilot stated that he had a positive rate of climb and thought he was high enough to begin a left turn and considered raising the flaps and contacting the tower when the airplane impacted the ground and slid into a building. A security video captured the airplane in a wings level attitude beyond the departure end of the runway. The airplane appeared to reach a height of about 20 ft above ground level before the left wing dropped and the airplane descended. Subsequently, it impacted a road and slid into a building, which resulted in substantial damage to both wings. Postaccident pictures of the airplane showed that the landing gear was extended and the flaps were retracted. The throttle control was pulled out about ½-inch, and the mixture control was about 1 ½-inch from full forward. The pilot reported that there were no preaccident mechanical malfunctions or failures with the airplane that would have precluded normal operation.

Probable cause

The pilot’s failure to properly configure the airplane during a go-around which resulted in the airplane exceeding its critical angle of attack and an aerodynamic stall at a low altitude. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
Minor
Weather conditions
Visual Meteorological Cond
Light condition
Dusk
Sky condition
NONE
Ceiling (ft)
0
Wind direction
0
Wind speed (kt)
4
Temperature (F)
71
Nearest airport
HELENA RGNL
Distance from field
0.25
Airport elevation
3877

Aircraft

RegistrationMakeModelDamageFAR part
N5204C — — SUBS 091

Sequence of events

#OccurrencePhase
2 Approach-VFR go-around Aerodynamic stall/spin defining Cruise
3 Approach-VFR go-around Collision with terr/obj (non-CFIT) Cruise

Findings

Finding
Personnel issues-Action/decision-Info processing/decision-Decision making/judgment-Pilot cause
Personnel issues-Task performance-Use of equip/info-Aircraft control-Pilot cause
Personnel issues-Action/decision-Action-Incorrect action selection-Pilot cause
Aircraft-Aircraft oper/perf/capability-Performance/control parameters-Airspeed-Not attained/maintained cause