N505GR Bell Helicopter Textron Canada 505 accident

NTSB CEN25LA381 · 2025-08-27 · Fort Worth, TX · near XS04

Docket — crew, injuries and powerplant

Factual narrative

The purpose of the flight with the manufacturer flight training academy was for a flight instructor to provide instruction to another flight instructor, who was a customer. About one hour into the flight at the manufacturer’s private flight training heliport, the manufacturer flight instructor was demonstrating a hover out of ground effect (HOGE) autorotation from a straight-in approach with termination on the lane. This was the first HOGE autorotation for the manufacturer flight instructor of the day. At the time of the maneuver, the manufacturer flight instructor reported the wind direction was variable, and the wind speed was light and variable with no gusting. He reported that he was late entering the HOGE autorotation due to a heliport traffic pattern restriction for noise abatement purposes. Near the end of the HOGE autorotation, with about 35 kts airspeed, he performed a small flare by pulling the nose up slightly. About 45 ft agl, he noticed the descent rate accelerated, requiring him to make a small input with the collective. He further noticed that the descent rate became excessive. About 20 ft agl he began pulling the collective to the top stop and he leveled the skids. The helicopter landed hard on the dry asphalt lane, the skids partially collapsed, and the helicopter came to rest upright on the right side of the lane with little forward motion. The helicopter sustained substantial damage to the underside of the fuselage. The manufacturer flight instructor reported there were no preimpact mechanical malfunctions or failures with the airframe or the engine that would have precluded normal operation. The manufacturer flight training academy reported that the accident was a mismanagement of the flight controls, and the manufacturer flight instructor should have identified the situation the helicopter was in sooner and executed a power recovery to arrest the descent rate. Postaccident investigation revealed that the manufacturer flight instructor, who had been employed with the manufacturer flight training academy for nine years, did not complete the required flight risk assessment tool before the instructional flight. The estimated density altitude for the closest meteorological reporting station was 2,484 ft.

Probable cause

The manufacturer flight instructor’s failure to maintain proper airspeed and a proper descent rate during a demonstrated hover out of ground effect (HOGE) autorotation, which resulted in a hard landing. Contributing to the accident was the manufacturer flight instructor’s failure to perform corrective action during the HOGE autorotation with a power recovery in a timely manner. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
BKN
Ceiling (ft)
3300
Visibility (sm)
10
Wind direction
110
Wind speed (kt)
5
Temperature (F)
86
Nearest airport
BELL SOUTH AIRFIELD
Distance from field
0.0
Airport elevation
473

Aircraft

RegistrationMakeModelDamageFAR part
N505GR BELL HELICOPTER TEXTRON CANADA 505 SUBS 091

Sequence of events

#OccurrencePhase
2 Approach-VFR pattern final Simulated/training event Cruise
4 Autorotation Attempted remediation/recovery Descent
5 Autorotation Hard landing defining Descent
6 Post-impact Evacuation Approach
7 Autorotation Loss of control in flight Descent

Findings

Finding
Personnel issues-Task performance-Use of equip/info-Aircraft control-Instructor/check pilot cause
Aircraft-Aircraft oper/perf/capability-Performance/control parameters-Descent rate-Not attained/maintained cause
Personnel issues-Psychological-Attention/monitoring-Task monitoring/vigilance-Instructor/check pilot cause
Personnel issues-Action/decision-Action-Incorrect action performance-Instructor/check pilot cause
Aircraft-Aircraft oper/perf/capability-Performance/control parameters-Airspeed-Not attained/maintained cause
Personnel issues-Action/decision-Info processing/decision-Identification/recognition-Instructor/check pilot cause