N75140 accident

NTSB ERA26LA193 · 2026-04-04 · Enterprise, AL

Docket — crew, injuries and powerplant

Factual narrative

The operator reported that following an uneventful flight, the pilot-in-command conducted a postflight inspection of the helicopter and noted a missing turn lock fastener stud on the tail rotor driveshaft cover of the vertical stabilizer. Additionally, the leading edge of one tail rotor blade near the blade tip was substantially damaged. The missing fastener was not located. The pilot reported that the fastener had been in place prior to the accident flight and that the tail rotor blade was not damaged. Thus, the fastener likely separated in-flight and contacted the tail rotor blade. The helicopter’s most recent inspection was completed about 2 months and 77 flight hours before the accident flight.

Probable cause

The in-flight separation of a turn lock fastener stud, which resulted in substantial damage to one tail rotor blade. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
170
Wind speed (kt)
6
Temperature (F)
81
Distance from field
0.0

Aircraft

RegistrationMakeModelDamageFAR part
N75140 — — SUBS 091

Sequence of events

#OccurrencePhase
1 Enroute-cruise Part(s) separation from AC defining Climb

Findings

Finding
Aircraft-Fluids/misc hardware-Misc hardware-Fasteners-Unknown/Not determined cause