N124CF Miner ROTORWAY EXEC 162F accident

NTSB NYC99LA072 · 1999-03-14 · MECHANICSBURG, PA

Docket — crew, injuries and powerplant

Summary

This was the pilot's first solo flight in a helicopter. He brought the helicopter to about a 6 inch hover and then drifted left and settled. The left rear skid contacted the ground and the helicopter rolled over on its left side. The pilot held a private pilot certificate for single engine airplanes but had not flown in several years. He had received 9.9 hours of dual instruction in the same model of helicopter, and was signed off for solo flight, but had not flown in the 44 days that preceded the accident flight.

Full narrative

On March 14, 1999, at 1038 eastern standard time, a homebuilt Rotorway Exec 162F, N124CF, was substantially damaged while the pilot was practicing hovering in an open field in Mechanicsburg, Pennsylvania. The certificated private pilot received minor injuries. Visual meteorological conditions prevailed and no flight plan had been filed for the flight conducted under 14 CFR Part 91.

In an interview, the pilot reported that he was on his first solo flight when the accident occurred. He had brought the helicopter to what he estimated was a 6 inch hover. After a few seconds, the helicopter drifted left and settled. The left rear skid caught on the ground and the helicopter rolled over on its left side. The frame and main rotor drive shaft were bent, and the main rotor blades were destroyed. The landing surface was a flat, hard packed field, about 5 acres in size which had recently been rolled.

According to the pilot, he held a single engine land rating for airplanes, and had logged 69.3 hours in airplanes; however, he had not flown in several years. As the construction of the helicopter neared completion, the pilot went to the kit manufacturer's facility in Arizona, where he received 9.9 hours of dual helicopter instruction in the same model. The pilot had been signed-off for solo flight on January 29, 1999, and had not flown again until the accident flight. The pilot's total flight time, including his recent helicopter dual instruction, was 79.2 hours.

The flight instructor who signed the pilot off for solo flight reported the pilot was "good" and did not remember him as having any specific problems.

According to Federal Aviation Administration Advisory Circular 90-87 HELCIOPTER DYNAMIC ROLLOVER:

"...During normal or slope takeoffs and landings with same degree of bank angle or side drift with one skid/wheel on the ground, the bank angle or side drift can place the helicopter in a situation where it is pivoting (rolling) about a skid/wheel which is still in contact with the ground. When this happens, lateral cyclic control response becomes more sluggish and less effective than for a free hovering helicopter. Consequently, if a roll rate is permitted to develop, a critical bank angle (the angle between the helicopter and the horizon) may be reached where roll cannot be corrected, even with full lateral cyclic, and the helicopter will roll over onto its side. As the roll rate increases, the angle at which recovery is still possible is significantly reduced...."

Probable cause

The pilot's inadvertent induced dynamic rollover. A factor in the accident was the pilot's lack of helicopter experience. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
Minor
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
BKN
Ceiling (ft)
9000
Visibility (sm)
7
Wind direction
110
Wind speed (kt)
6
Temperature (F)
36
Distance from field
0.0
Airport elevation
500

Aircraft

RegistrationMakeModelDamageFAR part
N124CF Miner ROTORWAY EXEC 162F SUBS 091

Sequence of events

#OccurrencePhase
1 250 Cruise
2 380 Cruise

Findings

Finding
24801 cause
34332 factor