N937S Bell 206L-3 accident

NTSB FTW94LA124 · 1994-04-15 · ENGLEWOOD, CO · near APA

Docket — crew, injuries and powerplant

Summary

WHILE CONDUCTING A TEST FLIGHT FOLLOWING INSTALLATION OF A FUEL CONTROL/GOVERNOR, THE ENGINE ACCELERATED TO MAXIMUM POWER AND COULD NOT BE CONTROLLED BY THE PILOT. THE PILOT SECURED THE ENGINE AND CONDUCTED AN AUTOROTATION. DURING TOUCHDOWN, THE MAIN ROTOR BLADES CONTACTED THE TAIL BOOM AND SEVERED THE TAIL ROTOR DRIVE SHAFT. EXAMINATION OF THE FUEL CONTROL/GOVERNOR REVEALED A PIECE OF ABRASIVE PAPER IN THE RESET SHAFT HOUSING. ACCORDING TO THE EXAMINATION REPORT, THIS WOULD CAUSE LOSS OF GOVERNOR CONTROL TO THE HIGH SIDE.

Full narrative

On April 15, 1994, at 1610 mountain daylight time, a Bell 206L-3 helicopter, N937S, sustained substantial damage while executing an autorotation following an engine malfunction. The pilot and passenger were not injured. Visual meteorological conditions prevailed and no flight plan was filed for this local test flight.

According to the pilot, control of the engine was lost during a test flight and the engine accelerated to maximum power. The pilot secured the engine and performed an autorotative landing. During the landing sequence, the main rotor came in contact with the tail pylon severing the tail rotor drive shaft. The test flight was being conducted due to installation of a fuel control/governor and the passenger (additional crew) was the mechanic who performed the work.

The engine, fuel control, and engine governor were removed and sent to the manufacturer, Allied Signal, for further examination. Under direction from local FAA personnel, a functional test and visual examination was conducted. The examination and testing revealed no discrepancies. (The narrative portion of the Allied Signal report is attached. For the full report, contact Allied Signal for report number ECD422-AR64.)

Following return of the parts to U. S. West, the aircraft owner, the fuel control and governor were sent to an independent testing laboratory. The results of their examination are attached and provide information that a foreign substance, described as a piece of abrasive paper, was found in the reset shaft housing of the governor. According to the report, under the operating conditions present at the time of the occurrence, if the reset rod sticks, fuel flow will increase.

Probable cause

THE PILOT'S FAILURE TO MAINTAIN ROTOR RPM, HIS DELAYED FLARE, AND IMPROPER TOUCHDOWN. A FACTOR WAS A FAILURE OF THE FUEL CONTROL/GOVERNOR TO THE HIGH SIDE WHICH REQUIRED THE PILOT TO PERFORM A FULL AUTOROTATION. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
50
Wind direction
330
Wind speed (kt)
8
Temperature (F)
66
Nearest airport
CENTENNIAL
Distance from field
0.0
Airport elevation
5883

Aircraft

RegistrationMakeModelDamageFAR part
N937S BELL 206L-3 SUBS 091

Sequence of events

#OccurrencePhase
1 350 Cruise
2 180 Cruise
3 200 Cruise

Findings

Finding
15909 factor
24558 cause
24535 cause
24567 cause