N6094B Cessna T210M accident

NTSB FTW95LA120 · 1995-02-17 · MONTROSE, CO · near MTJ

Docket — crew, injuries and powerplant

Summary

WHILE IN CRUISE FLIGHT, A TOTAL LOSS OF ELECTRICAL POWER OCCURRED. THE PILOT CIRCLED AN AIRPORT TO BURN OFF FUEL AND ATTEMPTED TO LOWER THE LANDING GEAR BY THE ALTERNATE METHOD. THE NOSE LANDING GEAR EXTENDED AND THE MAIN LANDING GEAR WOULD NOT EXTEND BEYOND THE TRAIL POSITION. THE PILOT CONDUCTED A PRECAUTIONARY LANDING AND THE AIRCRAFT DEPARTED THE SIDE OF THE RUNWAY DURING THE LANDING ROLL. A MECHANIC, WHO EXAMINED THE AIRCRAFT IMMEDIATELY FOLLOWING THE LANDING, FOUND A CONSIDERABLE AMOUNT OF AIRFRAME ICE. THE SAME MECHANIC LATER EXAMINED THE ELECTRICAL SYSTEM AND COULD FIND NO DISCREPANCIES. A BENT EXTENSION ROD WAS FOUND ON THE LANDING GEAR EXTEND MECHANISM.

Full narrative

On February 17, 1995, at 1115 mountain standard time, a Cessna T210M, N6094B, was substantially damaged during a precautionary landing at the Montrose, Colorado, Airport. The pilot and his two passengers were not injured. Visual meteorological conditions prevailed for this personal flight which departed Aspen, Colorado, for Telluride, Colorado, at 0900. No flight plan was filed.

While in cruise flight, the electrical system failed and the pilot elected to proceed to Montrose, an intermediate airport along his route of flight. He contacted the airport on a cellular phone and had equipment standing by while he orbited the area and tried to lower the landing gear by the alternate method.

The nose landing gear locked in place but the mains remained in trail. After burning off fuel, a landing was made and the aircraft went off the side of the runway sustaining damage to the right horizontal stabilizer and right wing tip.

According to a mechanic, who examined the aircraft, he could find no abnormalities in the electrical system. He stated, the electrical failure was probably the result of the pilot failing to turn on the alternator. The pilot said he used proper procedures in operating the electrical system.

According to the same mechanic, the inability of the pilot to lower the landing gear by the alternate method was due to a gear linkage rod being bent. The mechanic said that there was a considerable amount of ice on the aircraft, when he first examined it, following the landing, and that the ice may have interfered with landing gear actuation causing the rod to bend.

Probable cause

THE BENT LANDING GEAR EMERGENCY EXTENSION ASSEMBLY AND THE ACCUMULATION OF AIRFRAME ICE WHICH INTERFERED WITH LANDING GEAR ACTIVATION. A FACTOR WAS THE ALTERNATOR FAILURE FOR UNKNOWN REASONS. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
0
Temperature (F)
43
Nearest airport
MONTROSE
Distance from field
0.0
Airport elevation
5759

Aircraft

RegistrationMakeModelDamageFAR part
N6094B CESSNA T210M SUBS 091

Sequence of events

#OccurrencePhase
1 130 Cruise
2 190 Cruise

Findings

Finding
12005 factor
10407 cause
20000 cause
25000