N5561X Aero Commander S2R accident
NTSB FTW95LA145 · 1995-03-23 · GILLETT, AR
Docket — crew, injuries and powerplant
Summary
DURING AN AERIAL APPLICATION PASS THE ENGINE OIL PRESSURE DROPPED TO 40 PSI AND THE ENGINE LOST ALL POWER. THE AIRPLANE SLID INTO TREES DURING THE FORCED LANDING. AN ENGINE TEARDOWN REVEALED THAT THE ENGINE OIL PASSAGES WERE BLOCKED BY PIECES OF METAL WORN FROM THE MAIN ROD BEARING WHICH WAS SEIZED TO THE CRANKSHAFT. GEAR SPLINES WERE SEPARATED FROM THE CAM GEAR AND CAM GEAR DRIVE. THE CONDITION WAS DESCRIBED AS 'TYPICAL OF A HIGH TIME BEARING FAILURE.' THE ENGINE HAD 1,549 HOURS SINCE OVERHAUL. TBO WAS 1,200 HOURS.
Full narrative
On March 23, 1995, at 0815 central standard time, an Aero Commander S2R, N5561X, was substantially damaged during a forced landing near Gillett, Arkansas. The commercial pilot did not receive injuries. Visual meteorological conditions prevailed for the local aerial application flight.
During an interview, conducted by a Federal Aviation Administration inspector, and on the enclosed Pilot/Operator report, the pilot revealed the information in this paragraph. Upon completing the third swath and applying throttle, the engine power did not increase and the oil pressure dropped to 40 PSI. During the forced landing, as the pilot banked the airplane to the right, in order to avoid trees, the main gear collapsed as it struck the ground. Subsequently, the airplane slid into trees and the outboard 6 feet of the left wing was bent upward.
The operator reported that an engine teardown was performed at Covington Aviation of Tulsa, Oklahoma. The Vice President/Chief of Covington Engines (statement enclosed) reported that the main rod bearing was plated with silver and lead; however, with a high time bearing the metal wears and pieces of the metal stop up the oil passages and the bearing seizes on the crankshaft. The operator reported that this engine had 1,549 hours since the last overhaul. The manufacture's recommended time before overhaul (TBO) is 1,200 hours. Pieces of metal were found in the oil passages, the main rod bearing was seized to the crankshaft, and gear splines were separated from the cam gear and cam gear drive.
Probable cause
THE ENGINE MAIN ROD BEARING SEIZED TO THE CRANKSHAFT DUE TO WORN MASTER ROD METAL PIECES BLOCKING THE OIL PASSAGES. A FACTOR WAS AN ENGINE OVERHAUL WAS NOT PERFORMED BY COMPANY MAINTENANCE PERSONNEL. The National Transportation Safety Board determined the probable cause of this accident.
Circumstances
- Event type
- Accident
- Highest injury
- None
- Weather conditions
- Visual Meteorological Cond
- Light condition
- Day
- Sky condition
- NONE
- Ceiling (ft)
- 0
- Visibility (sm)
- 20
- Wind direction
- 45
- Wind speed (kt)
- 2
- Temperature (F)
- 64
- Distance from field
- 0.0
Aircraft
| Registration | Make | Model | Damage | FAR part |
|---|---|---|---|---|
| N5561X | AERO COMMANDER | S2R | SUBS | 137 |
Sequence of events
| # | Occurrence | Phase |
|---|---|---|
| 1 | 350 | Cruise |
| 2 | 180 | Cruise |
| 3 | 230 | Cruise |
| 4 | 310 | Cruise |
Findings
| Finding | |
|---|---|
| 14005 | cause |
| 15213 | cause |
| 14001 | cause |
| 14023 | |
| 24122 | factor |
| 19200 | factor |