N39019 Beech 1900C accident

NTSB FTW96IA080 · 1995-12-25 · DENVER, CO · near DEN

Docket — crew, injuries and powerplant

Summary

During landing flare, the elevator jammed. The pilot continued the landing using elevator trim to adjust nose attitude. Investigation revealed that an elevator counterweight bolt had backed out and jammed the elevators. The aircraft was on its first trip after being painted by an outside contractor and undergoing a return-to-service inspection by the operator.

Full narrative

On December 25, 1995, at 1419 mountain standard time, a Beech 1900C, N39019, owned by Beech Acceptance Corporation and operating as Continental Express Flight 2116 from Grand Island, Nebraska, to Denver, Colorado, with an en route stop at McCook, Nebraska, had the elevator jam during landing flare at Denver International Airport. There were no injuries to the 19 passengers or 2 crewmembers and no damage to the aircraft. The flight was operating under Title 14 CFR Part 135 when the incident occurred and a company VFR flight plan was filed. The flight departed McCook, Nebraska, at 1510.

The aircraft was on the second leg of its first flight after being painted and undergoing RII inspection. N39019 was picked up from Jet Center, in Hondo, Texas, at night, and flown to the company maintenance facility at Grand Island where the inspection was conducted prior to return to service.

According to the pilot, during the landing flare, the elevator jammed, limiting travel to about three inches. The pilot continued the landing using the elevator trim. Inspection revealed that an elevator counter balance weight cover plate bolt had backed out limiting the travel of the elevators.

According to the personnel at Jet Center in Hondo, Texas, they were assigned to scuff/sand the existing paint, apply a new top coat, and to balance according to the service manual. They were furnished with Beechcraft Maintenance Manual sections 55-20 and 55-00. According to Jet Center, no one remembers removing any counter weight, but they did add weight to the rudder. There was no record of work on the elevator counter balance weights. It was also stated that the aircraft was never reweighed.

Of the material reviewed by the NTSB, sections 27-30-00 and 55-0-00 of the Beechcraft Maintenance Manual, only section 27-30-00 states to rebalance the elevator after painting or other work.

Jet Center was furnished with the instructions on procedures to rebalance the elevators after painting. Though the section of the manual that requires rebalancing the elevator after painting (and other maintenance) was not furnished to Jet Center, the instructions to rebalance were included in the contract. However, the contract only stated to paint and rebalance. No description of what to rebalance was indicated.

Probable cause

failure by the outside contractor to perform adequate maintenance, and failure by the operator to perform an adequate inspection. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Incident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
320
Wind speed (kt)
3
Temperature (F)
48
Nearest airport
DENVER INTERNATIONAL
Distance from field
0.0
Airport elevation
5431

Aircraft

RegistrationMakeModelDamageFAR part
N39019 Beech 1900C — 135

Sequence of events

#OccurrencePhase
1 130 Cruise

Findings

Finding
10304 cause
10301
24100 cause
24102 cause