N3623T Schweizer 269C accident

NTSB FTW96LA095 · 1996-01-12 · SAN YGNACIO, TX

Docket — crew, injuries and powerplant

Summary

While herding cattle, the helicopter was moving laterally at about 70 feet out of ground effect, when the pilot heard a loud 'bang.' He said he applied anti-torque pedal to 'straighten' the helicopter with the flight path, but the helicopter did not respond to pedal inputs. The engine produced high RPM, but the tail rotor and main rotor RPM decreased. The pilot initiated an autorotation and landed on both skids. During touchdown with lateral movement, the helicopter rolled over and came to rest on its side. Inspection of the helicopter revealed that the swedged ball on the end of the clutch control cable had separated, which allowed the rotor drive system clutch assembly to disengage.

Full narrative

On January 12, 1996, at 0930 central standard time, a Schweizer 269C, N3623T, sustained substantial damage during a forced landing near San Ygnacio, Texas. The commercial helicopter pilot and his passenger were not injured. The aircraft was registered to and operated by Smith Helicopters under Title 14 CFR Part 91. The flight originated from a private airstrip near San Ygnacio, Texas, at 0900. Visual meteorological conditions prevailed for the local flight and no flight plan was filed.

The pilot reported that he heard a loud "bang" while hovering sideways at approximately 12 MPH at 70 feet out of ground effect. He responded by applying the right anti torque pedal to straighten the helicopter, however the helicopter did not respond to pedal inputs. According to the pilot, the engine produced high RPM, but the tail rotor and main rotor RPM decreased. The pilot initiated an autorotation. The pilot further reported that, during touchdown with lateral movement, the helicopter rolled over coming to rest on its right side. The tail boom, the engine mount, and the skids sustained substantial damage, and the tail rotor separated from the helicopter.

Inspection of the aircraft revealed that the swedged ball on the end of the clutch control cable had separated, which allowed the rotor drive system's clutch assembly to disengage.

Probable cause

Failure of the rotor drive system clutch assembly (separation of the swedge ball from the end of the clutch control cable), which resulted in disengagement of the rotor drive system, while the helicopter was in lateral movement at low altitude. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
70
Wind direction
280
Wind speed (kt)
4
Temperature (F)
54
Distance from field
0.0

Aircraft

RegistrationMakeModelDamageFAR part
N3623T Schweizer 269C SUBS 091

Sequence of events

#OccurrencePhase
1 130 Cruise
2 180 Cruise
3 380 Cruise

Findings

Finding
11005 cause
11000 cause
24520