N51763 Enstrom 280C accident

NTSB FTW96LA291 · 1996-07-03 · CASTLE ROCK, CO

Docket — crew, injuries and powerplant

Summary

The engine lost power and an autorotation was made. The helicopter was substantially damaged during the run-on landing on a rough field. Postaccident testing disclosed that when the magneto was rotated, none of the 12 leads produced a spark. When the distributor cap was removed, it was noted that none of the points opened when the magneto was rotated. An FAA inspector heard the engine missing on the day prior to the accident. He suggested to the pilot that the engine be checked before further flight. The pilot told the inspector that the condition was 'common on Enstrom helicopters when the engine is hot.'

Full narrative

On July 3, 1996, approximately 1155 mountain daylight time, N51763, an Enstrom 280C, was substantially damaged during a forced landing 8 miles south of Castle Rock, Colorado. The flight instructor and the private pilot receiving instruction were not injured. Visual meteorological conditions prevailed, and no flight plan was filed. The instructional flight was being conducted under Title 14 CFR Part 91. The flight originated at Englewood, Colorado, on July 3, 1996, approximately 1150.

According to the pilots, they were in a slow climb from 500 feet to 750 feet agl (above ground level). The engine began to sputter, then lost power. They made an autorotation and run-on landing on a rough field. During the landing roll, the left front skid and crossover tube collapsed, causing the helicopter to veer 90 degrees to the left and the main rotor blades to sever the tail boom.

An FAA airworthiness inspector examined the helicopter on November 20, 1996. According to his report, the magneto (Bendix m/n D4LN-2200, s/n 35413) had failed. When the magneto was rotated, none of the 12 leads produced a spark. When the distributor cap was removed, it was noted that none of the points opened when the magneto was rotated.

In a telephone interview, the inspector also said that on the day prior to the accident, he observed the helicopter landing at Centennial Airport, Englewood, Colorado. He said the engine was missing noticeably. He suggested that the pilots (the same ones involved in the accident) have the engine checked before further flight. According to the inspector, the instructor replied that the condition was "common on Enstrom helicopters when the engine is hot."

Probable cause

Total failure of the magneto. A factor was the pilot operating the helicopter with a known deficiency. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
50
Wind direction
20
Wind speed (kt)
7
Temperature (F)
91
Distance from field
0.0

Aircraft

RegistrationMakeModelDamageFAR part
N51763 Enstrom 280C SUBS 091

Sequence of events

#OccurrencePhase
1 350 Cruise
2 180 Cruise
3 190 Cruise

Findings

Finding
14801 cause
24007 factor