N5067C Bellanca 7ECA accident

NTSB NYC96LA166 · 1996-08-10 · BEDFORD, MA · near BED

Docket — crew, injuries and powerplant

Summary

The airplane went off the side of the runway during the landing, followed by collapse of the right main gear. The pilot reported: 'We came over the numbers at 80 mph indicated airspeed, and I flared the aircraft and we made a wheel landing, touching down at approximately 65 mph indicated airspeed. Everything was fine at first and then the aircraft veered to the right, into the wind. 'I corrected with left rudder pedal, and as I did, the tail wheel settled onto the runway. The aircraft made an abrupt turn to the left, and I realized we were in a ground loop. I added a little power, got the tail wheel off the ground, and recovered from the ground loop, but we were heading off the left side of the runway, approximately 85 to 90 degrees from runway heading. I had regained control of the aircraft, but we didn't have enough room to maneuver back onto the runway. I closed the throttle and started braking the aircraft. When we departed the runway, I leaned the mixture, and continued braking. Everything was fine until we hit a bump, and the aircraft jerked violently to the left, resting on the right side.' The pilot reported no mechanical malfunction. He stated the accident could have been prevented if he had 'additional training in crosswind landings for tail dragger aircraft.'

Full narrative

On August 10, 1996 about 1515 eastern daylight time, N5067C, a Bellanca 7ECA, a personal flight, had a loss of control during landing on runway 29 at Hanscom Field Airport, Bedford, Massachusetts. Visual meteorological conditions existed. The certificated private pilot and passenger were not injured. The aircraft was substantially damaged. The local flight was conducted under 14 CFR Part 91.

The airplane went off the side of the runway during the landing followed by collapse of the right main gear. The pilot reported: "We came over the numbers at 80 mph indicated airspeed, and I flared the aircraft and we made a wheel landing, touching down at approximately 65 mph indicated airspeed. Everything was fine at first and then the aircraft veered to the right, into the wind.

"I corrected with left rudder pedal, and as I did, the tail wheel settled onto the runway. The aircraft made an abrupt turn to the left, and I realized we were in a ground loop. I added a little power, got the tail wheel off the ground, and recovered from the ground loop, but we were heading off the left side of the runway, approximately 85 to 90 degrees from runway heading. I had regained control of the aircraft, but we didn't have enough room to maneuver back onto the runway. I closed the throttle and started braking the aircraft. When we departed the runway, I leaned the mixture, and continued braking. Everything was fine until we hit a bump, and the aircraft jerked violently to the left, resting on the right side."

The pilot reported no mechanical malfunctions. He stated the accident could have been prevented if he had "additional training in crosswind landings for tail dragger aircraft."

Probable cause

The pilot's inadequate compensation for wind conditions, and his failure to maintain directional control, which resulted in a ground loop/swerve. The variable wind condition was a related factor. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
0
Wind speed (kt)
8
Temperature (F)
28
Nearest airport
HANSCOM FIELD
Distance from field
0.0
Airport elevation
133

Aircraft

RegistrationMakeModelDamageFAR part
N5067C Bellanca 7ECA SUBS 091

Sequence of events

#OccurrencePhase
1 260 Cruise
2 320 Cruise
3 190 Cruise

Findings

Finding
20000 factor
24026 cause
24539 cause
24537
19200
10401