N121ER Socata TB-9 accident

NTSB MIA97LA071 · 1997-01-22 · DAYTONA BEACH, FL · near KDAB

Docket — crew, injuries and powerplant

Summary

On takeoff from runway 25L the airplane departed the left side of the runway, and collided with a runway marker sign. The pilot stated that he added full power, and as power was added the airplane started turning to the left. He said he slowly applied right rudder to correct for the 'left pulling force.' As he gained airspeed, the 'left force' was 'increasing.' The wind was coming from his 'left...south,' but he did not know the speed. He than applied right rudder, but he could not get the airplane to go straight and maintain runway centerline. The airplane countinued to the left, and the pilot elected to abort the takeoff. He stated, '...I was traveling at about 40-45 knots when [I] applied brake pressure. I felt the right side of the aircraft, what felt like lift off the ground. I feared I would flip the plane.' When he released the brakes, the airplane departed the hard surface of the runway onto the grass, and struck a runway sign before stopping. This was the student pilot's first solo flight, and he had no experience with crosswind takeoff procedure. Local weather at the time of the accident, reported that the wind was from 160 degrees, at 9 knots, with wind gusts to 17 knots

Full narrative

On January 22, 1997, about 1036 eastern standard time, a Socata TB-9, N121ER, registered to Embry-Riddle University was substantially damaged during takeoff, near Daytona Beach, Florida. The student pilot was not injured. Visual meteorological conditions (VMC) prevailed in the vicinity, and no flight plan had been filed. The local training flight was being conducted in accordance with Title 14 CFR Part 91. The flight was originating at the time of the accident.

The pilot stated that he checked his PQ (pilot qualification) code established by the University, and the code was 221. Code 221 required a maximum crosswind of 6 to 10 knots. After doing a run up he received clearance for takeoff and taxied onto runway 25L.

As the pilot added full power, the airplane started turning to the left. He slowly applied right rudder to correct for the "left pulling force." As he gained airspeed, the "left force" was "increasing." The wind was coming from his "left...south," but he did not know the speed. He than applied right rudder, but he could not get the airplane to go straight and maintain runway centerline. The airplane countinued to veer left, and the pilot elected to abort the takeoff. He stated, "...I was traveling at about 40-45 knots when [I] applied brake pressure. I felt the right side of the aircraft, what felt like lift off the ground. I feared I would flip the plane." When he released the brakes, the airplane departed the hard surface of the runway onto the grass, and struck a runway sign before stopping.

According to the FAA inspector's report, this was the student pilot's first solo flight from Dayton Beach Airport, and he had "no experience with crosswind takeoff procedure."

Local weather at the time of the accident, reported that the wind was from 160 degrees, at 9 knots, with wind gusts to 17 knots.

Probable cause

the student pilot's failure to maintain direction control of the airplane during takeoff. The crosswind was a factor. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
10
Wind direction
160
Wind speed (kt)
9
Temperature (F)
66
Nearest airport
DAYTONA BEACH INTL
Distance from field
0.0
Airport elevation
35

Aircraft

RegistrationMakeModelDamageFAR part
N121ER Socata TB-9 SUBS 091

Sequence of events

#OccurrencePhase
1 260 Cruise
2 310 Cruise

Findings

Finding
20000 factor
24539 cause
24537
20200