N540DH Staudaucher S300D accident

NTSB LAX97LA221 · 1997-05-31 · CHANDLER, AZ

Docket — crew, injuries and powerplant

Summary

During practice aerobic maneuvers, the pilot heard a loud bang and noticed that the right aileron had departed the aircraft. The pilot stated that the separation occurred during a 9-G pull from horizontal to a 45-degree nose high angle. A postaccident examination of the aircraft and aileron revealed that the aileron attach points were fabricated with automotive hardware welded to plates which had received no heat treatment. Shim plates were found under the attach brackets. Additionally, the aileron had been modified with an addition of aluminum plates to the trailing edge of the aileron without rebalancing the flight controls. The kit manufacturer said the pilot had found the two nuts which hold the aileron hinge to the aileron loose on several previous occasions. The examination revealed that there were signs of slippage and wear at the right center attach point where the shim plates were inserted.

Full narrative

On May 31, 1997, at 0715 hours mountain standard time, a Staudacher S300D, N540DH, had the right aileron separate during an in-flight aerobatic maneuver 5 miles south of Chandler, Arizona. The aircraft, registered to and operated by the owner/builder, sustained substantial damage when the aileron struck the horizontal stabilizer and bent it's spar. The certificated commercial pilot was not injured. Visual meteorological conditions prevailed and a flight plan was not filed. The flight originated in Chandler at 0700.

The Safety Board was notified of the extent of damage on June 24, 1997.

An FAA airworthiness inspector determined that the aileron attach points were fabricated with "automotive hardware welded to plates, receiving no further heat treatment, and then embedded in the aileron spar." Additionally, the aileron had been modified six flights previously with an addition of an aluminum plate to the trailing edge without rebalancing the flight controls. The inspector reported that the owner commonly attempted to improve the aircraft's flight characteristics by moving the aileron fore and aft with shim plates under the attach brackets. According to the FAA inspector, the parts showed signs of slippage and wear at the right center attach point where the shim plates were inserted.

According to the kit manufacturer, there are approximately 20 airplanes in service with this type of aileron attach fittings. The kit manufacturer has initiated a modification to the aileron attach fittings and the ailerons to remove the subject fabricated plate and bolt fittings. The kit manufacturer stated that all 20 airplanes in service will receive the modified ailerons and fittings. The owner reported to the kit manufacturer that the "two nuts that hold the aileron hinge to the aileron at the hinge that failed were found loose on several occasions."

Probable cause

The owner/pilot's decision to use automotive hardware, which had not been heat treated, and the practice of adding aluminum plates to the trailing edge of the aileron without rebalancing the flight controls, which resulted in the separation of the aileron at the attachment fitting. The National Transportation Safety Board determined the probable cause of this accident.

Circumstances

Event type
Accident
Highest injury
None
Weather conditions
Visual Meteorological Cond
Light condition
Day
Sky condition
NONE
Ceiling (ft)
0
Visibility (sm)
30
Wind direction
0
Temperature (F)
75
Distance from field
0.0

Aircraft

RegistrationMakeModelDamageFAR part
N540DH Staudaucher S300D SUBS 091

Sequence of events

#OccurrencePhase
1 130 Cruise

Findings

Finding
11303 cause
10312 cause
24111 cause
24102 factor